MABETT 2021 LED Grille Lights for Ford Bronco Installation Guide
- June 1, 2024
- Mabett
Table of Contents
MABETT 2021 LED Grille Lights for Ford Bronco
Package content
Installation Instruction
The Installation Steps of The Front Grille Lights Are as Follows:
- Open the hood first and prepare to remove the front grille.
- Locate the 4 screws in the location shown in (ii the picture.
- Use a tool to remove the 4 screws.
- Remove the front grille.
- Use a tool to remove the screws at the II-marked locations and remove the front grille bracket.
- The state after removing the front grille bracket is shown in the figure, and take out the Front Grille Lights.
- Snap into the front grille lights through the front grille, (note the position information on the back of the front grille lights)
- Repeat the steps to install the front grille Iii light, pay attention to the installation position as shown in the figure.
- Take out the front grille light cable.
- Pass the white connector of the front grille light cable through the hole shown in the front grille.
- The state of threading is shown in the figure.
- Repeat the operation, the thread completion status is as shown in the figure (note the completed status, the wiring head is in the same position)
- Connect the white connectors in pairs as shown, then straighten the wires.
- Restore and fix the front grille bracket.
- Flip to the front and check for exposed wires, if not, go to the next step.
- Put the installed front grille back on the original car, pay attention to place the power connector shown in the picture in the engine compartment.
- Use the original car screws to fix the front grille.
- Take out the two connectors on one end of the power cable.
- Find the position of the finger in the picture.
- Use a tool wrench to loosen the nut.
- Insert the ‘U’ connector and then tighten the nut.
- The completed state is shown in the figure.
- Locate the battery location in the engine compartment.
- find finger position.
- Insert the connector into the slot.
- The completed state is shown in the figure.
- Secure messy wires with accessory cable ties.
- Turn on the car power button.
- The front grille light comes on and the installation is complete.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>