babyono 300 3-In-1 Electric Breast Pump Instruction Manual
- June 5, 2024
- babyono
Table of Contents
babyono 300 3-In-1 Electric Breast Pump
introduction
- The three-phase program comprises 10 suction power modes
- massage to stimulate action
- massage to stimulate suction along with breast milk expressing
- breastmilk expressing discreetand comfortable touse in travel powered with rechargeable batteries possibility to feed the baby right after pumping
NOTE
Before the first use of the breast pump, please read carefully the operation
manual and the warnings contained therein. Please keep the instruction manual
for future reference.
- Please use the breast pump in compliance with its intended use described in the manual.
- Do not use the breast pump if it has been physically damaged. Do not place the breast pump in the vicinity of any devices that generatepowerful magnetic fields.
- Do not expose the breast pump to direct sunlight. Keepitoutofreachof children.
- Please keep the pumping unit in a dry place and do not immerse it in water.
- Before use, check all the elements and make sure they have not been damaged.
- Keepthebreastpump clean.The feeding bottle,the silicone breast cup,the breast pump body and the silicone valves may be sterilized. Make sure there is
- no liquid in the silicone tube. Do not use the breastpumpifanyliquidis visibleinthetube.lt hastobe driedfirst.
LISTOF PARTS
- silicone breast cup
- breast pump body
- breastshieldtunnel
- silicone membrane
- pump body cap
- silicone tubing
- pumping unit
- feeding bottle
- charger
- teat
- bottle cap
- cap
- silicone valve
- bottle sealing disc
ASSEMBLY INSTRUCTION
- lnsert the breast shield tunnel(3Jintothebreastpumpbody(2).
- Putthe silicone breast cup(l}onthebreastshieldtunnel.
- Put the silicone membrane (4) on the top of the breast pump body.
- Then put the pump body cap (5) over the membrane, turning it to the right until it blocks.
- Push the silicone valve (13) into the bottom of the body [make sure it’s been done correctly).
- Fix the feeding bottle(8).
- Put the silicone tubing (6) onto the aperture in the body, and connect the other end of the tube to the pumping unit(7).
BATTERYCHAR61N 6
NOTE! The battery must be fully charged before first use. The breast pump is
equipped with a lithium-ion battery,so it does not require the use of Mtype
batteries or a permanent connection to the power supply. It is recommended to
charge the breast pump before starting to express milk.The battery provided
with the breast pump can be charged approx. 300 times. Stop charging when the
battery is full in order to avoid harming the battery.ln order to extend the
life of the breast pump and reduce the electricity consumption by the battery
it should not be charged formorethan6 hours.
The breast pumpis equipped with a battery.ln order to charge it, connect the
breast pump to the charger and then to the power outlet. Charging will take
aboutlOOminutes.Whenthebatteryisfullycharged,alltheblueLEDs willlight up. The
breast pump can be charged at any time with no need to wait for the battery to
discharge.
After the battery is fully charged, the breast pump wUI operate for approx.
100 minutes. Note! The breast pump has a timer. After 45 minutes of continuous
operation, it switches off automatically. To resume the operation, press the
power button. Shortly before the battery is discharged, the power LED (first
on theleft)will start flashing.
OPERATION MANUAL
- Please bear in mind that stress has a tremendous effect on the amount of breast milk produced. Before you start pumping, make sure to eliminate any stressful situations. Try to relax and do not forget about hygiene. Wash your hands with water and soap,and your breast with water only.
- Many women feel increased thirst during breastfeeding breast milk expressing. Have something to drink at hand so that you don’t have to interrupt the pumping process.
- Do not feel discouraged in case you experience any problems at the beginning -in a short time you will work it out and breast milk pumping will no longer be a problem for you.
- Sit down comfortably and take a position in which you will be able to learn slightly forward.
- Make sure the breast pum about series have been charged.
- Take the sterilised breast pump body andmakesureallits elements have been Putin correctly.
- Put the breast pump shield onto your breast and turn on the device(C))
- The(l)))button providesthesuction stimulation,i.e.massage,via short,quickmovements.
- Then you can choose one of the two pumping programs:
- The first program comprises suction stimulation along with milk expressing( J))+(P). Expressing takes place after suction stimulating movements. By pressing the same button consecutively you will increase the suction power. The blue will then change its position to another.You can choose fromSsuctionpowermodes
- Thesecondmode isbreastmilk expressing((P ).This program does nothing else but milk expression. Each consecutive pressing of the button will increase the suction power. In theme of this program, you also have 5 suction power modes to choose from.
- If you don’t feel any suction, make sure air has not got in between your breast and the silicone breast cup. also,take your breast out and put it back in the breast shield tunnel.
- When milk has stopped flowing out, finish the pumping.
- Amounts of expressed milk will vary, as they depend on the level of the lactation, time of day and the amounts of liquids you drink.When your breasts are full, milk pumping may even take 30minutes.
- After finishing the pumping, disconnect the silico net ubing from the pump, wash the other elements of the body and prepare them for sterilization. NOTE: DO NOT IMMERSE THE PUMPING UNIT IN WATER. IF YOU HAVE WASHED THE SILICONE TUBING, DRY IT THOROUGHLY BEFORE USING.
BREAST PUMP CLEANING
Disassemble all the elements of the breast pump in reverse order in relation
to the assembly instruction. Before the first and each further use, all the
elements of the breast pump body should be thoroughly washed in warm water
with baby soap,and rinsed several times. The breast pump body, breast shield
tunnel andthe feeding bottle may be put in a dishwasher{the upper shelf).
However, please bear in mind that they should be removed from the dishwasher
immediately after finishing the rinsing code and dried,they may not be heated
up. This could lead to deforming and permanent damage of the elements. The
elements of the body that come into contact with milk may be sterilized in
BabyOnosteam sterilization bags.
Never use any disinfectants to clean them. Store the product in a warm and dry
place. Do not expose the product to direct sunlight or put it close to other
hot places.
NATURAL NURSING FEEDING BDTTLEANDTEAT
The enclosed teat is intended for feeding bottles from the Natural Nursing
product family. Before each use, please check the teat quality by stretching
it in different directions. lf the teat is damaged, it should be immediately
replaced with anew one. Do not enlarge the apertures in the teat due to the
risk of damaging the silicone structure. Due to hygiene considerations it is
recommended to replace the teat with a new one once in every 1 -2 months.
IMPORTANT FOR YOUR BABY’S HEALTH AND SAFETY
- Neverleaveyourchild unat ten ded during feeding.
- Neverusefeedingteatsas soothers.
- Continuous and prolonged sucking of liquids may cause tooth decay.
- Alwayscheckthefood temperaturebeforefeeding.
- Please remember that the sterilized bottle elements must be assembled with dean’s hands.
The product complies with the requirements of there 14350standard.
EXPRESSED BREAST MILKSTORA6E
IMPORTANT : Please make sure any expressed breast milk is correctly
stored! incorrectly stored breast milk loses its nutritive value and may even
be harmful to your baby.
We recommend Babyono sterile bags for breast milk storing and freezing.
STilRAGEPlACE
| STORAGE TIME
---|---
FOR HEALTHY BABIES| FOR PREMATURE
AND ILL BABIES
In room temperature| 8-12hours| 1-4hours
ln a fridge(S”O| 3-4days| 24-48hours
lnafreezer compartment(-10° ()| 2weeks| 1week
ln afreezer(-18° 0| 6-12months| 3-6months
NOTE
- Any thawed breast milk must not be frozen again. Any unused milk should be discarded.
- Do not mix any thawed breast milk with freshly pumped breast milk.
- Please freeze only fresh breast milk.
- Breast milk should be defrosted slowly. To do this, frozen milk should be placed in a refrigerator until it takes liquid form.
- To warm the breast milk, it is recommended to use a water bath with a temperature not exceedingSG°C.
- To preserve its nutritive value, breast milk must not be boiled, or heated up directly on a cooker or in a microwave!
- Ready to serve breast milk should have the human body temperature,i.e.nomorethan 37″C.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>