TAC-CDS9-005 Sniper Running Boards Instruction Manual
- June 1, 2024
- TAC
Table of Contents
TAC-CDS9-005 Sniper Running Boards
SNIPER RUNNING BOARD
PART #: TAC-CDS9-005
FITS:
2019-Up Chevy Silverado 1500 Crew Cab 2020-Up Chevy Silverado 2500-3500 Crew
Cab 2019-Up GMC Sierra 1500 Crew Cab
2020-Up GMC Sierra 2500-3500 Crew Cab
Torque & Tools
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.
Part List
TOOLS
PLEASE NOTE THAT THE FOLLOWING PICTURES ARE BASED ON THE PASSENGER SIDE INSTALLATION
INSTRUCTION
STEP 1
Start the installation under the Passenger/Right side of the vehicle.
- For “Early” 2019 models, locate the 8 plugs along the bottom edge of the body. Mounting Brackets will bolt to the 1st, 3rd, 4th and 6th threaded mounting holes, (Fig 1).
- For “Late” 2019 models, all (4) mounting locations will be used.
(Fig 1) Passenger/Right “Early” rocker panel mounting locations (arrows) NOTE: Hold Bracket up to body panel to help determine the correct mounting locations.
STEP 2
Remove the plastic plugs from the
Passenger/Right front mounting location, (Fig 2).
(Fig 2) Remove plastic plugs to uncover threaded inserts
STEP 3
Select (1) Mounting Bracket. Attach the Mounting Bracket to the factory threaded holes with (2) 8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Figs 3 & 4). Do not tighten hardware.
(Fig 3) Attach (1) Mounting Bracket to the mounting location
STEP 4
Repeat Steps 1 – 3 to attach the (3) remaining Passenger/Right Mounting Brackets to the (3) remaining locations along the rocker panel, (Figs 5—7). Do not tighten hardware.
STEP 5
Select the Passenger/Right Running Board. NOTE: The Passenger/Right Running Board will have a “05-R” on the front. Carefully place Running Board on the brackets. IMPORTANT: Do not slide Running Board front to back on the Brackets or damage to the finish may result. Attach Running Board to the Mounting Brackets with (8) 8mm Combo Bolts, (Fig 8). Do not tighten hardware.
STEP 6
Level and adjust the Running Board and fully tighten all hardware.
STEP 7
Repeat Steps 1—6 to attach the Driver/Left Running Board.
STEP 8
Do periodic inspections to the installation to make sure that all hardware is
secure and tight.
Attention
To protect your investment, do not use any type of polish or wax that may
contain abrasives that could damage the finish.
Mild soap may be used also to clean the Running Boards.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>