hager JKD202SPD Protection Devices Surge Protection Kit Instruction Manual
- June 3, 2024
- hager
Table of Contents
hager JKD202SPD Protection Devices Surge Protection Kit
Surge Protection Kit JKD 250A Type II
Parts list:
- 16mm sq neutral cable
- 16mm sq L1/L2/L3 cable
- 4 x M5 Hex HT Screws
- 1 x Type II SPD sub assembly
Screw the surge protection sub-assembly on the right hand side of the
enclosure as shown using the 4 off Hex head High Torque screw to the chassis
at 5Nm
Connect the L1/L2/L3 cable lugs to the Incomer using the existing incomer
bolts provided, torque to 13Nm and connect the Neutral cable to the neutral
bar to the left of the MCCB, then terminate into the relevent terminals on the
SPD
The device may only be connected and installed by an electrically skilled person. National standards and safety regulations must be observed.
The device must be checked for external damage prior to installation. If any
damage or other defects are detected in this check, the device must not be
installed.
Its use is only permitted within the limits shown and stated in the
installation instructions.
Opening or otherwise tampering with the device invalidates the warranty.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>