TAC 233900 Gloss Black 3 Instruction Manual
- June 1, 2024
- TAC
Table of Contents
TAC 233900 Gloss Black 3
INSTALLATION INSTRUCTIONS
3” SIDEBARS 2010-2024 TOYOTA 4 RUNNER (Excl.2010-2013 SR5/2010-2024 Limited/2020-2021 Nightshade Edition/2022-2024 TRD Sport Models/models with Lower Rocker Panel Extensions) PART# 233900
SIDEBARS 2010-2024 TOYOTA 4 RUNNER (INCL. 2024 40TH ANNIVERSARY & EXCL. 10-13 4RUNNER SR5, 10-24 LIMITED AND 19-22 NIGHTSHADE EDITION OR MODELS WITH LOWER ROCKER PANEL EXTENSIONS)
PARTS LIST
| Qty | Description | Qty | Description |
|---|---|---|---|
| 1 | Driver/Left Sidebar | 12 | 8-1.25mm x 30mm Hex Bolts |
| 1 | Passenger/Right Sidebar | 12 | 8mm Lock Washers |
| 2 | Front Mounting Brackets | 12 | 8mm x 22mm OD x 2mm Flat Washers |
| 4 | Center & Rear Mounting Brackets | 12 | 8mm x 25mm Combo Bolts |
PROCEDURE
-
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY. ASSISTANCE IS RECOMMENDED.
-
Starting on the driver side front of the vehicle, remove the (2) factory hex bolts or plastic plugs from the threaded holes in the bottom of the body panel, (Figure 1). Select (1) Front Mounting Bracket. Line up the mounting holes in the Bracket with the threaded holes. Bolt the Mounting Bracket to the vehicle using the included (2) 8mm x 30mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Figure 2). Do not tighten the hardware at this time.
-
Repeat Step 2 for Center and Rear Bracket installation, (Figures 3 & 4).
-
With assistance, carefully place the Driver/Left Sidebar onto the (3) Brackets.
WARNING: Do not rotate the Sidebar on the cradle or the finish on the Sidebar may be damaged. Line up the threaded holes in the bottom of the Sidebar with the slots in the Mounting Brackets. Attach the Sidebar to the Mounting Brackets with the included (6) 8mm x 25mm Combo Bolts, (Figure 5). Do not tighten at this time. -
Level and adjust the Sidebar properly and tighten all hardware.
-
Repeat Steps 2 – 5 for passenger Sidebar installation.
-
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment , wax this product after installing. Regular
waxing is recommended to add a protective layer over the finish. Do not use
any type of polish or wax that may contain abrasives that could damage the
finish.
For stainless steel : Aluminum polish may be used to polish small
scratches and scuffs on the finish. Mild soap may be used also to clean the
Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Driver Side Installation Pictured
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>