Waverspeed DEFENDER 500 Lift Kit for Can Am Defender Installation Guide

Waverspeed DEFENDER 500 Lift Kit for Can Am Defender

Product Information

Specifications

• Product: Lift Kit
• Model: LK-DEF-1619-LC
• Compatibility: Fits Can Am Defender 500, 800, 1000
• Lift Height: 2 inches
• Contents:
  • 4x Strut Bottom Brackets (Front and Rear)
  • 8x Hex Head Bolts M101.560-30
  • 8x Nylon Lock Nuts M10
  • 8x Flat Washers M10

Product Usage Instructions

Before Installation

1. All modifications must be installed by qualified personnel and in compliance with local regulations.
2. Refer to the OE Service Manual for proper disassembly/reassembly procedures.
3. Keep the stock hardware for future installations.

Installation Steps

1. Park the UTV on a clean, level surface and block the front wheels for safety. Apply the parking brake.
2. Jack up the front end to lift the front wheels off the ground. Support the frame with jack stands.
3. Remove the front wheels and tires.
4. Loosen the bolts and nuts of the front bottom shock.
5. Install the new bracket onto the factory shock mount using provided bolt, washer, and nut. Torque to 40 lb-ft.
6. Re-install the shock to the new bracket using provided bolt, washer, and nut. Torque to 40 lb-ft.
7. Repeat steps for the opposite side and reinstall wheels and tires.
8. Repeat the same installation process for the rear of the vehicle.

After Installation

1. An alignment by a certified professional is required.
2. Check hardware after the first 500 miles and then every 1000 miles for maintenance.

FAQ

Q: Do I need to perform any maintenance after installing the lift kit?

A: Yes, it is recommended to check hardware after the first 500 miles and then every 1000 miles to ensure everything is secure.

Q: Can I install the lift kit myself?

A: It is advised to have qualified personnel perform the installation to ensure compliance with regulations and proper installation.

LIFT KIT FITS CAN AM DEFENDER 500 800 1000

BEFORE INSTALLATION

• All modifications must be installed by qualified personnel and in compliance with your local modification regulations.
• Prepare OE Service Manual for the model/year of the vehicle. Refer to the manual for proper disassembly/reassembly procedures of OE and related components.
• Keep the stock hardware for future installations.
• This kit includes front and rear strut brackets to provide a 2″ full lift.

KIT CONTENTS

INSTRUCTIONS

1. Park the UTV on a clean, level surface and block the front wheels for safety. Apply the parking brake.
2. Place a jack under the center of the front end and lift until the front wheels clear the ground. Support the frame with jack stands to make sure A-arms and shocks can droop to full extension.
3. Take off the front wheels and tires.
4. Loosen the bolts and nuts of the front bottom shock.
5. Install the new bracket onto the factory shock mount using provided bolt, washer, and nut. Torque to 40 lb-ft.
6. Re-install the shock to the new bracket using provided bolt, washer, and nut. Torque to 40 lb-ft.

7. Repeat on the opposite side. Put on the wheels and tires.
8. The rear installation is the same with the front.

AFTER INSTALLATION

An alignment by a certified alignment professional with experience in aligning lifted vehicles must be performed.
Check hardware after the first 500 miles and then every 1000 miles.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>