STANDESK SENKO-1-X Senko Task Light Instruction Manual
- June 1, 2024
- STANDESK
Table of Contents
STANDESK SENKO-1-X Senko Task Light
Specifications
- Product Name: SENKO TASK LIGHT
- Model: SENKO-1-X
- Power Supply: 120V / 60Hz
- Manufacturer: StandDesk
- Address: 100 Kuebler Road Easton, PA 18040
Product Usage Instructions
Installation Instructions
To install the SENKO TASK LIGHT, follow these steps:
- Unbox the product and remove all packaging materials.
- Connect the power adapter to the lamp.
- Plug the power adapter into a 120V / 60Hz wall outlet.
Dimmer Switch
The SENKO TASK LIGHT features a dimmer switch for adjusting brightness. To
use the dimmer switch:
- Locate the dimmer switch on the lamp.
- Adjust the switch to increase or decrease the brightness according to your preference.
Safety Advice: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAN ICES-5(B)NMB-5(B)
Contact Information:
If you have any questions or need assistance, please contact StandDesk at
the provided address.
FAQ
-
Q: How do I change the light bulb in the SENKO TASK LIGHT?
A: To change the light bulb, first make sure the lamp is unplugged. Then, carefully remove the old bulb and replace it with a new one of the same wattage and type. -
Q: Can I use LED bulbs with the SENKO TASK LIGHT?
A: Yes, you can use LED bulbs as long as they are compatible with the lamp’s specifications. Make sure to check the wattage and type of bulb recommended for use with the SENKO TASK LIGHT.
SENKO TASK LIGHT
Installation Instructions
SAFETY ADVICE
- Parts of the lamp may become hot during use. Do not touch the light bulb or parts surrounded by the light bulb (for example glass or reflector) while in use.
- Never try to take off the LED bulb by yourself, the LED part is not replaceable.
- The external flexible cable (power supply) for this lamp cannot be replaced. If the cable is damaged, the lamp must be scrapped.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
CAN ICES-5(B)NMB-5(B)
StandDesk
100 Kuebler Road Easton, PA 18040
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>