OMNISIGHT MEGA1 Millimeter Wave Radar User Manual

OMNISIGHT MEGA1 Millimeter Wave Radar User Manual

MEGA1 USER MANUAL

I. UPON RECEIPT

Once you have received the unit, please remove it from the packaging and verify that the following components are also contained within the box:

• Radar unit
• Base
• Rubber grommet

II.ORIENTATION AND INSTALLATION

Before the device can be plugged in, please follow the orientation and installation guide to place the device at the desired location and angles for usage.
Once the unit is appropriately mounted, supply power via a CAT5/CAT6 cable with a PoE supply; the supply can be an injector, router, or switch.

III.CONFIGURATION

After the unit is connected, you can further configure and setup the parameters by logging in with your supplied credentials to www.omnisightusa.com

FCC: 2A6OYMEGA1IC: 28582-MEGA1

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation )

The license-exempt transmitter / receiver contained in this device complies with the Innovation, Science and Economic Development Canada NRCs applicable to devices radio exempt from license. Operation is permitted under the following two conditions: (1) The device may not cause interference; (2) The device must accept any interference radio interference, even if the interference may compromise its operation.

IV. Regulatory Information

Modifications (FCC 15.21)

Changes or modifications to this equipment not expressly approved by Omnisight, Inc. may void the user’s authority to operate this equipment.

Radio Frequency Interface (RFI) (FCC 15.105)

This device has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 Subpart B, of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential environment. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

• Reorient or relocate the receiving
• Increase the separation between the equipment and
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for

RFx warning statement

In order to comply with FCC and ISED RF Exposure requirements, a minimum separation distance of 200 cm must be maintained between the device and all persons during normal operation
Afin de se conformer aux exigences d’exposition RF FCC et ISED, un minimum une distance de séparation de 200 cm doit être maintenue entre l’appareil et toutes les personnes pendant le fonctionnement normal
Suppliers Declaration of Conformity 47 CFR 2.1077 Compliance Information
Unique Identifier: 2A6OY-MEGA1 Responsible Party – U.S. Contact Information Omnisight, Inc 295 Seven Farms Drive Suite C-289 Daniel Island, SC 29492

Website: www.omnisightusa.comContact Email: info@omnisightusa.com

Read More About This Manual & Download PDF:

References

• OmniSight - Traffic, Parking, Environmental Sensors
• OmniSight - Traffic, Parking, Environmental Sensors

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>