INOI A540 Smart Phone User Guide

June 1, 2024
inoi

INOI logo A540 Smart Phone
User GuideINOI A540 Smart Phone INOI A54 4+256GB
QUICKSTART GUIDE

A540 Smart Phone

Control audio, ringer and notification volume with volume buttonsINOI A540
Smart Phone - figConnect headphones via 35 jack

Pull the tab on the lower right corner to remove the cover and install one or two Nano SIM cards
INOI A540 Smart Phone - fig2For more information on how to operate this device access 24.inoi.com

FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference  that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a  residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is  no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is  encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This Tec desk Model 6 meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of  scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: Smart phone (FCC ID: 2A9SNA540 ) has also been tested against this SAR limit. The highest SAR value reported under this standard during product  certification for use at the ear is 1.196W/kg and when properly worn on the body is 1.186W/kg. This device was tested for typical body-worn operations with the back of the handset kept 10mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 10mm separation distance between the user’s body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third- party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

CE Maintenance

  1. Use careful with the earphone maybe excessive sound pressure from earphones and headphones can cause hearing loss.

  2. Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.

  3. The product shall only be connected to a USB interface of Tybee-C.

  4. Adapter shall be installed near the equipment and shall be easily accessible.

  5. EUT Operating temperature range: 0° C to 40°C .

  6. Adapter: The plug considered as disconnect device of adapter
    Power supply and ADP(rating):
    Input: 100-240V~50/60Hz 0.35A
    Output: 5V, 2A

  7. The device complies with RF specifications when the device used at 10mm you’re your body.

  8. To prevent possible hearing damage. Do not listen at high volume levels for long periods.

  9. Operations in the 5.15-5.25GHz band are restricted to indoor usage only.

This product may be used in the following European member states subject to the following restrictions. For products that operate in the frequency band 5.150 to 5.250 GHz, wireless access systems (WAS), including radio local area networks (RLANs), shall be restricted to indoor use.

| AT| BE| BG| CH| CY| CZ| DE| DK| EE| EL| ES
---|---|---|---|---|---|---|---|---|---|---|---
Fl| FR| HR| HU| IE| IS| IT| LI| LT| LU| LV
MT| NL| NO| PL| PT| RO| SE| SI| SK| TR|

Declaration of Conformity
INOI Limited hereby declares that this Smart phone is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. In accordance with Article 10(2) and Article 10(10),This product is allow
INOI logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals