tp-link 7106511077 Indoor Access Point Installation Guide
- June 1, 2024
- tp-link
Table of Contents
Installation Guide
Indoor Access Point
Note: Images may differ from your actual product.
Network Topology
A typical network topology for the AP is shown below.
Some APs can be configured and monitored centrally via a controller. For details, refer to the product specifications and the manual for the relevant product or controller. You can get the controller from https://www.tp- link.com or contact the sales staff.
Hardware Installation
■ Option 1: Ceiling Mounting
Follow the steps below to install the AP with the provided accessories:
Note: The mounting bracket and the accessories (quantity and size) may
vary by product.
| |
---|---|---
Washers| Pan-head Screws| Wing Nuts
- Remove the ceiling tile.
- Place the mounting bracket in the center of the ceiling tile. Mark positions for the screw holes and a position for the Ethernet cable hole. Drill holes for the screws and a hole for the Ethernet cable at the marked positions.
- Secure the mounting bracket to the ceiling tile using pan-head screws, washers and wing nuts.
- Feed the Ethernet cable through the hole and set the ceiling tile back into place.
- Connect the Ethernet cable to the Ethernet port. Attach the AP to the mounting bracket by aligning the arrow mark on the AP with the arrow mark on the mounting bracket, then rotate the AP until it is locked into place.
■ Option 2: Wall Mounting
Follow the steps below to install the AP with the provided accessories:
Note: The mounting bracket and the accessories (quantity and size) may
vary by product.
|
---|---
Plastic Wall Anchors| Self-tapping Screws
- If your Ethernet cable feeds through the wall, position the mounting bracket and feed the Ethernet cable. Mark positions for the screw holes and then drill holes at the marked positions.
- Insert the plastic wall anchors into the holes.
- Secure the mounting bracket to the wall by driving the selftapping screws into the anchors. Make sure that the shoulders of the mounting bracket are on the outside.
- Connect the Ethernet cable to the Ethernet port on the AP.
- Attach the AP to the mounting bracket by aligning the arrow mark on the AP with the arrow mark on the mounting bracket, then rotate the AP until it is locked into place.
Power Supply
■ Power via PSE Device or Power Adapter
Some APs can be powered via the power adapter or the PSE device (such as a PoE
switch) which complies with Power Source Class 2 (PS2) or Limited Power Source
(LPS) of IEC 62368-1.
Note: Availability depends on the actual product. Please refer to the
product specifications.
Via PoE Switch
Via Power Adapter
■ Power via PoE Adapter
Some APs can be powered via the PoE adapter.
Note: Availability depends on the actual product. Please refer to the
product specifications.
For technical support, the user guide and other information, please visit https://www.tp-link.com/support/?type=smb , or simply scan the QR code.
https://www.tp-link.com/support/?type=smb
© 2024 TP-Link
7106511077
REV3.0.0
References
- Anatel — Agência Nacional de Telecomunicações
- WiFi Networking Equipment for Home & Business | TP-Link
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>