GLITI QM028 12W Lamp User Manual
- June 1, 2024
- GLITI
Table of Contents
GLITI QM028 12W Lamp
Product Specification
Important Safety Information
- Place the device on a stable, level, and non-slipper surface.
- Do not use the lamp with a damaged power cord or plug.
- Do not let the device in wet conditions, keeping away from water sources.
- Do not look directly at the light source to avoid eye imitation.
- Do not disassemble the product in case of an electrical shock(LEDs light can not be replaced).
- Do not use a power supply that exceeds the rated voltage range.
- Long-term use beyond the rated voltage range may damage the lamp.
- If you do not use the lamp for long periods, please disconnect it from the outlet.
Touch Screen Display
Product Functions
Packing List
How to Use
Charging & USB Charge
-
Insert the power input wire into the interface DC 10V) behind the base.
-
- After connecting the output of usb power supply, it ‘ can charge other phones (output 5V 2A).
- Click the button.
- Touch the key to adjust the colour temperature.
-
Colour Modes:
Bright white, cool white, natural light, yellowish, yellow. -
Slide Dimming & Night Light
- The brightness of the lamp can be adjusted by sliding a finger over the dimmer panel.
- Touch the button to activate the night light, it can be adjusted by 3 colour modes.
-
Auto-off Timer with 2 Modes
- Green Light Flashing: 30 minutes
- Blue Light Flashing: hours
- The light source will auto-turn off after the timing mode you choose (night light can not be timed).
FCC Requirement
changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interterence, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, under Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used by the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for uncontrolled environments. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>