AB Moto Brutale 1000 License Bracket Installation Guide
- June 1, 2024
- AB Moto
Table of Contents
AB Moto Brutale 1000 License Bracket
Product Information
Specifications:
- Product Name: LED License Plate Light and Turn Signal Kit
- Material: CNC Machined Aluminum
- Compatibility: Universal fit for motorcycles
- Includes: CNC bracket, turn signal unit, license bracket, license plate light bracket, license light, screws
Product Usage Instructions
Step 1: Disassembly
Disassemble the stock license holder arm and housing for the LED license
light, turn signal, and reflector.
Step 2: Disconnecting Components
Disconnect the LED license light and turn signals from their quick
connects.
Step 3: Rerouting Wires
Remove the bottom wire cover underneath the swing arm to reroute the wires for
the license light and turn signals to the battery compartment area.
Step 4: Accessing Battery Compartment
Remove the four screws in picture 1 to access the battery compartment.
FAQ
Q: Can this kit be installed on all motorcycle models?
A: The kit is designed for universal fit on most motorcycles, but please check
compatibility before installation.
Q: Do I need any special tools for installation?
A: Basic tools such as screwdrivers are required for installation. Refer to
the user manual for specific tool requirements.
ASSEMBLING
- Disassemble stock license holder arm as well as the housing for the LED license light, turn signal, and reflector.
- Disconnect the LED license light and turn signals from their quick connects.
- Remove the bottom wire cover underneath the swing arm to reroute the wires for the license light and turn signals to the battery compartment area.
- To access the battery compartment, start by removing the four screws in picture 1.
- Remove the screw in Picture 2
- Remove side panels by first removing the post from the grommet in the rear by pulling it toward you (Pic 3) and gently pull the panel out and away towards the back of the bike to unhook from post (Pic 4).
- Before removing the seat, remove the screw holding on the two rear fairings from the underside of the bike.(Pic 5)
- Once the seat is removed, remove the 4 screws in pic 6 to detach the taillight. The top two screws are underneath the carbon fibre/plastic tailpiece and can be unscrewed from the side without the removal of the carbon/plastic tailpiece.
- Remove the taillight by pulling towards the rear of the bike. Once removed, unscrew the two bolts in the picture where the bracket will be installed into (Pic 7)
- Attach the CNC bracket using the 2 M3x16mm self-tapping screws. (Pic 7)
- Attach the turn signal unit using the 2 M4X12mm screws. (Pic 8)
- Attach the license bracket using the 2 m5x10mm screws (Pic 9)
- Attach the license plate light bracket by placing it in between the license plate and using the license plate screws to secure it. (Pic 10)
- Attach the license light using the 2 M3x10mm screws.
- Wires can be run in between the plastic and metal tail pieces on either the right or left side. (Pic 11)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>