dahl 620-31-04F Angle Dishwasher Elbow Instructions

June 1, 2024
DAHL

dahl 620-31-04F Angle Dishwasher Elbow

dahl 620-31-04F Angle Dishwasher Elbow-PRODUCT

Product Information

Specifications

  • Model: 620-31-04F
  • Usage: Compression fitting for copper pipe and plastic tube
  • Material: Brass
  • Installation: Compression fitting

Product Usage Instructions

Installation Process

  1. Turn off the water supply before starting the installation.
  2. Install the product according to the following steps:
    • For Copper Pipe:
    • Ensure the pipe is clean, de-burred, round, and cut square.
    • Slide the nut, then the ring, and finally the valve onto the pipe.
    • Tighten firmly using a small wrench, but do not over-tighten.
    • For Plastic Tube:
    • Follow the instructions provided by the tube manufacturer.
    • A special ring, nut, or insert may be required for compression.
    • For Hose:
    • Tighten the hose firmly but avoid over-tightening.
  3. Turn on the water supply and check for any leaks.
  4. Ensure compliance with local plumbing codes to avoid issues.
  5. Avoid exposure to corrosive agents to maintain product integrity.

FAQ

Q: Can I use pipe dope or PTFE tape with this product?

A: For compression on copper pipe, do not use pipe dope or PTFE tape. The pipe must be clean, de-burred, round, and cut square for proper installation.

Q: How should I tighten the compression fitting on a plastic tube?

A: Follow the instructions provided by the tube manufacturer as a special ring, nut, or insert may be required for compression on a plastic tube.

Q: What should I do if I encounter leaks after installation?

A: If leaks are detected after installation, ensure that all components are securely tightened. If issues persist, contact a professional plumber for assistance.

Usage Instructions

Instructions for 620-31-04F

  • Turn off the water supply. Install product. Turn on the water supply, and check for leaks. dahl assumes no responsibility for failure due to improper installation.
  • Abide by local plumbing codes. Do not expose to corrosive agents.
  • COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape.
  • The pipe must be clean, de-burred, round, & cut square. Slide nut then rings, then valve onto the pipe.
  • Tighten firmly with a small wrench. DO NOT OVER-TIGHTEN.

Compression on the plastic tube:

  • Follow the tube manufacturer’s instructions; a Special ring, nut, or insert may be required.
  • HOSE: Tighten firmly. DO NOT OVER-TIGHTEN.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals