BIRCH HARBOR LED Puck Lighting Kit Instruction Manual

 LED Puck Light Kits

White

• (2) Extension cables
• Plug-in power supply with on/off switch
• (3) Puck lights with 23 in. leads

Multicolor

• (2) Extension cables
• Plug-in power supply with on/off switch
• Infrared controller & receiver
• Remote control
• (3) Puck lights with 23 in. leads

Safety Information

• Consult a local licensed electrician or electrical contractor if you are not sure about the installation. 
• All electrical connections must be in accordance with electrical codes in effect in your region. 
• Do not use in wet locations. This product is not intended for lighting of aquariums. 
• Use indoors only. 
• Route and secure the cables so that they will not be pinched or damaged. 
• Use only insulated staples or plastic ties to secure cords, do not damage the cables. 
• This pucks are not suitable for dimmers, motion sensor or electric timer.

Surface installation

1. Carefully separate the LED puck light from its surface mounting ring using a flat screwdriver.
2. Locate the desired position for LED puck light and mark the location of installation holes. Note: Be sure notch for wire faces direction you want wires to run.
3. Pre-drill holes in marked location.
4. Install the surface mounting ring using the screws provided.
5. Snap housing into surface ring. Be sure to pull excess wire through notch to prevent pinching or bunching of wires.
6. Make connection to power supply.

a) FLATHEAD SCREWDRIVER
b) WIRE
c) LED PUCK LIGHT
d) SURFACE MOUNTING RING

a) MOUNTING SURFACE

Recessed installation (open space only)

1. Carefully separate the LED puck light from its surface mounting ring using a flat screw driver.
2. Locate the desired position for LED puck light. 
3. Drill a 2-1/2 in. (65 mm) hole in marked location. 
4. Feed wires through hole then insert LED puck light. The spring clips on the LED puck light will snap to the edge of the hole to hold puck in place. 
5. Make connection to power supply.

a) SURFACE MOUNTING RING
b) FLATHEAD SCREWDRIVER

a) WIRE
b) MOUNTING SURFACE
c) SPRING CLIPS
d) LED PUCK LIGHT

Multicolor puck lights only

1. POWER SUPPLY CABLE

2. INFRARED CONTROLLER

3. INFRARED RECEIVER

4. IMPORTANT:
   Make sure to connect arrow to arrow.

5. LED PUCK LIGHT

Remote control

A. On/Off

B. Brightness: On static state: increases or decreases the color brightness. On dynamic state: slows down or accelerates the color change.

C. R, G, B, WW: Choose color.
Red, Green, Blue, White.

D. Flash key: Fast alternating colors

E. Strobe key: Strobe color effect

F. Fade key: Gradual change of 8 colors.

G. Smooth key: Slow alternate color change (3 colors)

NOTE: Direct the remote control towards the infrared receiver to manipulate RGB colors of the pucks.

Troubleshooting

LED puck lights will not light

• Make sure the outlet has power and that a switched outlet switch is on

Remote unresponsive

• Move closer to the the receiver
• Check the battery and replace if needed

For support, visit birchharborlighting.com.

One-year limited warranty. This product is for dry location use only. Improper installation, improper powering, abuse, or failure to use this device for its intended purpose will void warranty. Proof of purchase is required for all returns.

© 2024 Birch Harbor Lighting, Baltimore, MD 21225

References

• Birch Lighting LED Products – Birch Harbor Lighting

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>