BIRCH HARBOR MD 21225 Multicolor LED Strip Light Kit with Remote Instruction Manual
- June 1, 2024
- BIRCH HARBOR
Table of Contents
BIRCH HARBOR MD 21225 Multicolor LED Strip Light Kit with Remote
Safety Information
- Do not stare directly at LEDs
- Do not power while LED tape is still on the reel
- Keep low-voltage wiring separate from high-voltage wiring runs
- For indoor/dry location use only
Installation
Unwind tape from reel and test prior to installation.
Tape may be cut to size at the copper pads or solder joints. Cut interval: 4 in.
Remove protective backing from adhesive and press tape into place.
Tips
- Make sure surface is clean and dry before installing
- Do not bend the LED tape
- Use painters tape to temporarily install to test
Operation
Control of the kit will be either via inline on/off switch or included remote.
Troubleshooting
LED strip will not light
Make sure the outlet has power and that a switched outlet switch is on
Remote unresponsive
- Move closer to the the receiver
- Check the battery and replace if needed
For support, visit birchharborlighting.com
One-year limited warranty
This product is for dry location use only. Improper installation, improper powering, abuse, or failure to use this device for its intended purpose will void warranty. Proof of purchase is required for all returns.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>