GLASSFACTORY FI 1712322118 110x210cm Aitta Extra Large Full Length Mirror With White Frame Instruction Manual
- June 1, 2024
- GLASSFACTORY FI
Table of Contents
GLASSFACTORY FI 1712322118 110x210cm Aitta Extra Large Full Length Mirror With White Frame
Before Starting The Installation
Please read the instructions carefully and check that the product is
completely intact before you start the installation.
Installation instructions are also available as a video. Read the QR code
below.
Keep the mirror always dry. Do not let it get wet. Moisture can cause
oxidation of the mirror.
You Will Need The Following Tools And Supplies
- Pen and measure + spirit level
- Screwdriver or screw gun
- For installation in a stone wall, you will need an impact driver/drill and a 6 mm blade
The included screws and plugs are for stone or wooden walls
A Step-by-step Guide For Hanging Your Mirror
-
The mirror frame has mounting holes for mounting. The mirror can be installed both vertically and horizontally. Even if you install the mirror to lean against the wall, always attach the mirror to the wall as well.
-
Plan the location of the mirror and measure the positions of the mounting holes. Don’t forget to check the horizontal alignment.
The supplied brackets are suitable for stone and wooden walls. If your wall material is different, we recommend getting screws that match your wall material. -
Mount the screws to the wall. Leave them about 1 cm out from the wall.
-
Place the mirror into the screws. Be careful not to scratch the back of the mirror. It’s advisable to have two people when lifting the mirror.
-
Remove the plastic shield from the top of the mirror. If there is adhesive residues on the mirror surface, it can be easily removed with a microfiber cloth or with glass cleaning detergent.
Installation instructions are also available as a video. Read this QR code.
Care Instructions
The need to clean the mirror depends on the environmental conditions. We recommend cleaning the glass surfaces regularly, at least once a year. Good cleaning tools for mirrors are a damp cloth or sponge, a soft lint-free cloth, and a rubber squeegee. Glass cleaning detergent can be used for mirror cleaning. For tough stains can be used denatured alcohol or acetone, but be careful not to let the substance come into contact with metal structures or the back of the mirror.
Please note
Never use abrasive or abrasive materials or tools. Use a soft and clean cloth
for cleaning. To prevent scratching, cleaning tools should be clean and as
soft as possible; always remove any loose dirt before abrasive cleaning.
www.glassfactory.fi
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>