Senhozi SE-0001-BN Bidet Sprayer for Toilet Instruction Manual
- June 1, 2024
- Senhozi
Table of Contents
**Senhozi SE-0001-BN Bidet Sprayer for Toilet Instruction Manual
**
INSTALLATION INSTRUCTION
Accessories Checking:
Important Note:
- It is highly recommended to turn off the T-Valve after each use.
- Please do not use jet water flow spray on eyes.
- All of our accessories for products are the unitive color.
- If you have any issues, please kindly contact us senhozi@outlook.com
| NO. | Part Name | QTY |
|---|---|---|
| 1 | Bidet Sprayer Head | 1 |
| 2 | T-valve | 1 |
| 3 | Hose | 1 |
| 4 | Holder | 1 |
| 5 | Toilet Hook | 1 |
| 6 | Washer | 1 |
| 7 | Wall amounted Accessories | 1 |
| 8 | Toilet Hook Screws | 1 |
| 9 | Plumbing Tape | 1 |
You will check the connection
between the water supply from the wall to the toilet. If it uses a flexible
hose, you can proceed with the installation. If it uses a rigid pipe, then you
will need to buy a flexible hose and replace it.
Toilet Hook Mounted Usage
STEP 1:
Shut Off The Water Supply That Comes From the wall or floor to the Toilet.
Flush the Toilet by Holding down the flushing handle until the toilet tank is
completely emptied
- Connect well the holder to the Hook
- Hang the complete Toilet Holder on Tank wall properly
- Close water Tank
**STEP 2 :
Connect the T-Valve to the toilet tank Use the washers provided at the
connection. Remember. Washers should be lying flat. TIPS: USES THE TEFLON TAPE
TO THE TOILET TANK CONNECTION IF NECESSARY
STEP 3 :
Connect the flexible water supply hose to the bottom of the T-Valve
STEP 4 :
**
- Connect one end of the provided hose to the remaining branch of the T-Valve and the other end to the bidet sprayer. Use the washers provided at each end. Remember. Washers should be lying flat at each end
- Turn on both water supply at the wall and the T-Valve. Check for any leaks at all connection points. Keep water supply on for 10 minutes and constantly check all connection points for leaks. Use plumbing tape on threads if necessary. Remember that you can control sprayer’s water pressure through the T-Valve
Wall Mounted Usage
STEP 1 :
Drilling hole into the wall Put Shower Holder with provided Screw into the
wall properly
**STEP 2 :
Connect the T-Valve to the toilet tank Use the washers provided at the
connection. Remember. Washers should be lying flat.
TIPS: USES THE TEFLON TAPE TO THE TOILET TANK CONNECTION IF NECESSARY
STEP 3 :
Connect the flexible water supply hose to the bottom of the T-Valve
STEP 4 :
**
- Connect one end of the provided hose to the remaining branch of the T-Valve and the other end to the bidet sprayer. Use the washers provided at each end. Remember. Washers should be lying flat at each end
- Turn on both water supply at the wall and the T-Valve. Check for any leaks at all connection points. Keep water supply on for 10 minutes and constantly check all connection points for leaks. Use plumbing tape on threads if necessary. Remember that you can control sprayer’s water pressure through the T-Valve
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>