Zhiwoyi HY-025 2 In 1 Wireless Charging Stand User Guide
- June 1, 2024
- Zhiwoyi
Table of Contents
Zhiwoyi HY-025 2 In 1 Wireless Charging Stand
User Guide
Product name: 2 IN 1 Wireless charging stand
Input: DC5V3A/9V3A
Output (Phone): 5W/10W/15W
Output (Smart watch): 2.5W
Packing List
Wireless Charger x1
User manual x1
Tip:
- It is recommended to use PD or QC 3.0 adapter.
- Do not disassemble this product at will.
- Do not use this product in a high temperature, humid environment, please stay away from fire and water.
- When using the power adapter, please make sure that the cable is fully inserted into the power adapter before plugging the adapter into the power outlet.
- When using this product, please do not place metal foreign objects (such as keys, coins, batteries or jewelry) on it, otherwise it will cause abnormal charging or hotness.
FCC Warning
This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:
- This device may not cause harmful interference,and
- this device mustaccept any interference received,including interference that may cause undesiredoperation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note :This equipment has been tested and found to comply with the limits
for a Class B digital device,pursuant to part 15 of the FCC Rules.These limits
a redesigned to provide reasonable protection against harmful interference in
aresidential installation.This equipment generates uses and can radiate
radiofrequency energy and,if not installed and used in accordance with the
instructions,may cause harmful interference to radio
communications.However,there is noguarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception,which can be determined by
turning the equipment off and on,the user is encouraged to try to correct the
interference by one or more of the following measures:-Reorient or relocate
the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The FCC certification of this device refers to RF exposure testing perfomed in
typical operating conditions,where a person is no closer than 20 centimeters
from the device surface at all times,except for non-repetitivepatterns with
transient time intervals in the order of a second.Only in the stated
conditions,the device is shown to fully comply with the FCC RF Exposure
requirements of KDB 447498.