ANTSKU 66.9 Wide Hall Tree Instruction Manual
- June 1, 2024
- ANTSKU
Table of Contents
ANTSKU 66.9 Wide Hall Tree
Dimensions
- Width-66.9 inch
- Depth-15 inch
- Height-72 inch
Important – Please read these instructions fully before starting assembly
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
- Check you have all the components and tools listed on the following pages.
- Remove all fittings from the plastic bags and separate them into their groups.
- Keep children and animals away from the work area, small parts could choke if swallowed.
- Make sure you have enough space to layout the parts before starting.
- During assembly do not stand or put weight on the product, this could cause damage.
- Assemble the item as close to its final position (in the same room) as possible.
- Assemble on a soft level surface to avoid damaging the unit or your floor.
- Parts of the assembly will be easier with 2 people.
- To reduce the likelihood of damaging your product please ensure that your power drill is set on a low torque setting.
Care and maintenance
- Only clean using a damp cloth and mild detergent, do no use bleach or abrasive cleaners.
- From time to time check that there are no loose screws on this unit.
- This product should not be discarded with household waste. Take to your local authority waste disposal centre.
Handy Hints
- Assemble all parts and bolts loosely during assembly, only once the product is complete should you fully tighten the bolts
- Regularly check and ensure That all bolts and fittings are tightend properly.
WARNING
In order to help prevent overturning – please follow these instructions
To help prevent product toppling over please follow the below steps:-
- Do not low charan i cil for hang on revied it applicable)
- Do not open more than one drawer at a time
- Do not place heavy items in the top drawers
- Do not place heavy items on top of the furniture, unless the furniture has been designed for this purpose
Components – Fittings
Please check you have all the panels listed below
Note: The quantitie below are the correcet amount to complete the
assembly. In some cases more fittingsmay be supplied than are
required
Tools required
Using Camlocks
Step 1
Connect the male camlockas as directed in the assembly instructions using a screwdriver.
Step 2
Push the male camlock into the entry hole.
Step 3
Insert the female camlock as shown in the instruction.
Note: ensure that the arrow on the top of the camlock points towards the entry
holefor the male camlock.
Step 4
Turn the female camlock clockwise with a screwdriver. You should feel a click when the camlock is locked in place. The joint is now secure.
Parts
Installation Instruction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>