Fortdows 2008 Car Stereo Fit for Jeep Grand Cherokee Radio User Manual
- June 1, 2024
- Fortdows
Table of Contents
USE MANUAL
Car Stereo radio
for Jeep Grand Cherokee WK 2008-2013
Central Control Disassembly and Operation
Post-installation rendering
- Radio
- GPS
- Rear Camera Signal Wire
- MIC
- RCA Cable
- Canbus
- 8-PIN Connector (for Canbus)
- 4Pin USB
- 6Pin USB
A: Please refer to the top of the back page for detailed wiring
instructions
B: Notes:
1. If you encounter no sound, connect the amplifier control wire to the ACC
power.
Kind tips
We provide 7*24 hours of after-sales technical support to solve your installation and operation problem. If you have any questions about the installation or the product itself, please con-tact us by message, we will reply your solution within 24 hours.
After—sales Email address: Fortdows.cam@gmail.com
A: red cable (1) connect together
to the backup light”+”
B: black cable (2) is connected to the backup light”-”
C: The reversing detection cable (G5) is connected to the white cable (3)
which extending from the video input cable
D: Cut and interface and connect the two wire (Thired from the black
line, don’t cut it off)
Why is the rear camera not displaying?
The setting path is Setting → System → Factory → Password is [1617] The head unit pre-set, compatible with the format AHD camera. it is compatible with the complimentary AHD rear camera (some head units may not provide), the compatible format is “AHD”, If the reverse gear is en-gaged and the rearview camera effect is not displayed, please manually adjust the settings.
If you use Original car backup Camera. please select “CVBS-NTSC”. It will reset to fit the original rear camera reversing camera format.
Carplay Connect method
Method 1: How to use the carplay?
(1) Enable the Bluetooth on your iphone and pair it with the radio.
[Pairing code: 0000] (2) Turn on the main page and open “Zlink5” app.
(3) After opening “Zlink5”, Check the iphone, “Use CarPlay car?” will pop
up, click to select “Use CarPlay”.
(4) The initial connection may take 1 to 5 minutes due to the large
number of mobile phone file in-formation.
Method 2: How to use Android auto or Carplay (wired)?
(1) Be sure your android’s phone has be installed the ‘android auto’ app.
(2) Connect the phone with the radio via original usb cable.
(3) Turn on the main page and open “Zlink5” app.
Note:
If you want to reset this navigator, please enter the Factory password: 1617
or 3368.
FCC warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>