ASUS EBG15 Gigabit VPN Wired Router User Guide
- June 1, 2024
- Asus
Table of Contents
EBG15 Gigabit VPN Wired Router
Gigabit VPN Wired Router
Router con cable Gigabit VPN
Gigabit VPN
EBG15
Router Overview
| 1 Power LED | 5 WAN (Internet) port |
|---|---|
| 2 USB 3.2 Gen 1 LED | 6 WAN/LAN ports |
| 3 Reset button | 7 LAN ports |
| 4 USB 3.2 Gen 1 port | 8 Power (DCIN) port |
- For detailed information, please refer to
https://asus.click/ExpertWiFiEBG15
Specifications：
| DC Power adapter | DC Output: +12V with max 1.5A |
|---|---|
| Operating Temperature | 0~40 °C/0~70 °C |
| Operating Humidity | 50~90% / 20~90% |
LED Indicators
Speed LED (Green)| Link/Act LED (Amber)
1G| ON| 1G/100M/10M| Blinking
100M/10M| OFF| No Traffic| ON
Reboot modem and ensure its connection is ready
Notice: Unplug modem for 10 sec then plug back in
Prepare your ASUS router and power it on
[App] Scan the code and download ASUS ExpertWiFi app for setup
ASUS ExpertWiFi| https://asus.click/asusexpertwifii|
https://asus.click/asusexpertwifia
[Web] Open a web browser and navigate to
http://expertwifi.net for web setup
Support Wall Mount
IMPORTANT! DO NOT mount this equipment higher than 2 meters.
NOTE: It is recommended to use screws with a size of PA5.7*2mm.
ASUS Recycling/Takeback Services
ASUS recycling and takeback programs come from our commitment to the highest
standards for protecting our environment.
We believe in providing solutions for you to be able to responsibly recycle
our products, batteries, other components, as well as the packaging materials.
Please go to http://csr.asus.com/english/Takeback.htm for the detailed
recycling information in different regions.
REACH
Complying with the REACH (Registration, Evaluation, Authorisation, and
Restriction of Chemicals) regulatory framework, we published the chemical
substances in our products at ASUS REACH website at
http://csr.asus.com/english/REACH.htm
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
-
This device may not cause harmful interference.
-
This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
FCC RF Caution Statement
WARNING: Any changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
FCC RF Exposure information:
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. The exposure standard employs a unit of
measurement known as the Specific Absorption Rate, or SAR. The SAR limit set
by the FCC is 1.6 W/kg. Tests for SAR are conducted using standard operating
positions accepted by the FCC with the EUT transmitting at the specified power
level in different channels. The FCC has granted an Equipment Authorization
for this device with all reported SAR levels evaluated as in compliance with
the FCC RF exposure guidelines. SAR information on this device is on file
with the FCC and can be found under the Display Grant section of
www.fcc.gov/oet/ea/fccid.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>