T R SPORTS BK-TB 20 Inch Folding Bicycle Instruction Manual

: June 1, 2024
: T R SPORTS

Table of Contents

Folding Bicycle Installation Instructions:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

**T R SPORTS BK-TB 20 Inch Folding Bicycle Instruction Manual

**

Folding Bicycle Installation Instructions:

Unfolding
01>>next

Open the packaging with the bike in the folded state and release the folding clasp.
02>>next

Align and match the folding parts.
03>>next

Pull up the latch to the indicated position.
04>>next

Use the quick-release wrench to appropriate- ly tighten the quick-re- lease screws.
05>>next

Secure the quick-re- lease clasp as shown in the diagram.

Handlebar Installation:
01>>next

Rotate the front fork with the curved side facing forward (as shown in the diagram).
02>>next

Lift the handlebar to match the folding position.
03>>next

Tighten the quick-release screw upwards.
04>>next

After securing, fasten the plastic clasp onto the quick-release screw.

Adjusting Brake Lever Angle:
01>>next

Use a hex wrench to loosen the screws fixing the handle.
02>>next

Adjust the handle position.
03>>next

Reinforce and fix the screws.

Adjusting the V-Brake System:
01>>next

Loosen the brake cable fixing screw.
02>>next

Squeeze both sides of the brake pads with one hand while tightening the brake cable
03>>next

Keep the brake pads squeezed and then fix the brake cable screw.

Adjusting the Cantilever Brake System:
01>>next

Loosen the rear brake cable fixing screw.
02>>next

Pull in the indicate- ed direction to maintain the cor- rect position.
03>>next

Tighten the brake cable, then fix the screw.

Adjusting the Brake System:
01>>next

Check the gap on both sides between the brake pads and the disc brake.
02>>next

Loosen the fixing screws to adjust the gap between the brake pads and the outer side of the disc brake.
03>>next

Adjust the gap between the inner disc brake and the brake pad.
04>>next

Different models have different brake types, so please refer to the corresponding tutorial based on the ordered model for adjustments.
Adjusting the Rear Mudguard Tilt Angle:
01>>next

Check for deviations.
02>>next

Loosen the screws slightly for adjustment.
03>>next

Push the indicated position by hand.
04>>next

Adjust as shown after ad justment.
Installing Pedals:
01>>next

When installing pedals, check for the “L” and “R” markings at the end of the pedal threads.
02>> next

Left pedal corresponds to “L” and should be tightened counterclockwise; right pedal corresponds to “R” andshould be tightened clockwise (both towards the front of the bike).
03>> next

Ensure to tighten with a wrench in the forward wheel direction in one go. (Reg- ularly check for pedal tightness.)