OZARKE SKØRTER Multi Tier Contemporary Crystal LED Chandelier Instruction Manual
- June 1, 2024
- OZARKE
Table of Contents
**OZARKE SKØRTER Multi Tier Contemporary Crystal LED Chandelier Instruction Manual
**
Thank you for shopping with Ozarké, we really appreciate your business. Our goal is to provide an excellent customer service before, during and after delivery. We’ve included a guide on how to install this light, should you require additional assistance please feel free to email us at info@ozarke.com and one of our customer service reps will reach out to assist you.
Before you get started:
Turn off electrical power to the fixture at the electrical panel. Use the appropriate voltage tester to ensure no power is present at the fixture before you begin work. Do not rely on a wall switch to protect you from electrical shock. Installation requires an experienced electrician.
Assembly Inventory:
Please check the assembly inventory. If you find anything missing reach out to our customer service team
A- 450 x Glass Rod
B- 818 x Crystal Ball
C- 1 x Hanging Board
D- 3 x Lamp Metal Round Layer E- 9 x screws
F- 25 x E14 bulbs
G- 1 x remote control
H- 450 x butterfly clasp pins for glass rods
I- 818 x pins for crystal ball (40 mm length)
Tools needed (not included):
1 x Screw Driver
1 x Electric Drill
Installation Instructions
Step 1:
Use a pencil or a pen to mark the drilling position. You can use the hanging
bracket to mark the position of the light. It is very important to ensure you
account for the wiring position on your wall or ceiling.
Step 2:
Using a drill, drill holes into the wall where you marked in step 1.
Step 3:
Insert drywall anchors into each hole. Don’t damage or force the anchor in the
hole. If the hole is small,try to make the hole(s) bigger.
Step 4:
Screw the hanging bracket to the wall using a screw driver. Don’t attach the
lamp. This step to be completed after wiring.
- Hanging Borad
- Screw
- M6 Nut
- M6 Decoration nut
- Expansion of the screw
Hanging Borad Install
Step: 5
Pass the pin through the hole in the crystal ball, then bend the pin as shown
in the image, then hang it in the hole of the lamp frame.
Step 6:
Hang the crystal rods as shown in image 1.1 (1st page), then finish assembling
the lamp frame.
Gold Wire: Live, Gold wire: Neutral, Yellow wire: Ground Connect
the lamp wires to the wall wires, and tuck inside the lamp or inside the wall.
Step 7:
Attach the lamp body to the hanging board using the provided screws.
Now you may turn your electrical power back on and test the lamp
Remote Control Instructions
A: LED Control On/Off
B: Bulbs Control On/Off
Sleep: Light turns off after 15 seconds
On/Off: Controls the whole fixture
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>