HIHUOS B0BXSFV3K4 Dusk to Dawn Outdoor Wall Lights User Manual
- June 1, 2024
- HIHUOS
Table of Contents
HIHUOS B0BXSFV3K4 Dusk to Dawn Outdoor Wall Lights
User Manual
- WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
- With Dusk to Dawn Mode: Auto turn on at night time when ambient brightness less than 20 LUX, auto turn off at daytime when brightness over 100 LUX. You don’t need to turn it on/off manually, free your hands, and save your bills on electricity.
HIHUOS Porch Light Generic Installation Video
QR Code:
Link: https://youtu.be/ToKnlsQFzvg
Install Steps
- Attach the mounting plate to the outlet box by using two mounting screws.
- Pull out the wires and grounding wire from the outlet box. Make wire connections using the wire nuts, as follow:
- Connect the hot wire (usually black installation) from the fixture to the black wire from the power source.
- Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
- Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap with the green grounding screw. Then connect it to the house grounding wire with the wire nut. Carefully put the wires back into the outlet box.
- Attach the back plate to the mounting plate by inserting the screws, then secure it with two nuts.
CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the wall surface to prevent water from seeping into the outlet box.
Turn on the power at fuse or circuit box.
Troubleshooting
SYMPTOM
If the light isn’t on
| DAY/NIGHT
Day
| POSSIBLE CAUSE
Light only work on night
| SOLUTION
Keep of all sensor for testing
---|---|---|---
Night| Wall switch or circuit breaker is off| Turn on wall switch or circuit
breaker
Light bulb may be burned out| Test the light bulb on normal working light
fixture
Light bulb is loose| Tighten the light bulb
Incorrect or loose wire connections| Check wire connections
Too much sunlight is shining onto sensor in the early evening| Relocate
fixture away from western facing wall
Too much another light is shining onto motion sensor. such as a street lamp or
other light fixture| Eliminate or turn off other lights, block other light
shining onto motion sensor. or relocate fixture
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>