MOUSIKE D15-4 Magnetic Door Catch Ultra Thin Cabinet Magnets Instruction Manual

Table of Contents

MOUSIKE D15-4 Magnetic Door Catch Ultra Thin Cabinet Magnets

MOUSIKE D15-4 Magnetic Door Catch Ultra Thin Cabinet
Magnets

New Upgrade Mini Design Cabinet Door Magnet

Adopting high-quality magnets to provide long-lasting strong magnetic force.
The shell is stamped from real stainless steel, which is not easy to rust in a humid environment.
The installation of nail free adhesive is firm and sturdy, and it is not as easy to age.
Mini slim size, round design, which can be installed without damaging beautiful furniture.

Occasions: drawer, cabinet, wardrobe, bathroom, bedroom, sliding door, mailbox, shutter, etc.
This product is not suitable for doors with tension, such as caused by damage to hinges.
This product is not suitable for scenarios where the gap is too large and the spacing cannot be reduced.

Nail-free Installation Steps and Note

Apply adhesive on the cabinet door magnet (Don’t apply it on the side where the magnet can be seen, it is correct to apply it on the smaller back side). Don’t paint too much.
Stick the magnetic catch on the door and press firmly to adhere sturdily.
Stick the strike plate on the door magnet, Apply adhesive on the strike plate.
Close the cabinet door and press firmly, open it after 12 hours.( If there is tension on the door, it needs to be installed separately to ensure that the magnet and impact plate fit together when the door is closed.)

Important Note with 3m Double-sided Adhesive

Clean the surface of the magnets catch and cabinet door.
Apply adhesive to the magnet and strike plate, and peel off the adhesive film on the strike plate and magnet base.
Stick the Cabinet Magnets components after removing the film onto the back of the cabinet door or drawer.
After 12 hours(very important),close the door and check that the magnet holds the door closed.

Clean the surface to ensure there are no stains or water stains.
If you install with 3m double-sided adhesive, you can first stick the double-sided adhesive on the catch and strike plate, press firmly, wait for a few hours, and then remove the red tape, this makes it easier to remove the red tape(use tools such as pin tweezers).