Weiqi WQ-03 Bluetooth Earphone User Manual
- June 2, 2024
- Weiqi
Table of Contents
Weiqi WQ-03 Bluetooth Earphone
Specification
Power on : Open the top cover of the charging compartment
Power off : Put the earphones in the charging case and turn them of
Join operation
- Open the top of the charging case and take out the headphones
- Device Search for the corresponding model
- Select the corresponding model pair can be used!
Do not close the cover of the charging box during the connection process, and ensure that the left and right earphones are connected. If the earphones cannot be opened after opening the cover, please put the earphones in the charging box, close the cover, plug in the charger and charge for at least one hour
Look out
- Do not disassemble or modify the product by yourself;
- Do not store the product in a humid or hot environment;
- do not use headphones in the rain water or other liquids into the product, resulting in damage to the product;
- When using headphones, don’t pull hard, wear and put gently
- When driving a car, riding a bicycle or walking on the road, do not use headphones, otherwise it may cause traffic accidents
- When using headphones, please pay attention to control the appropriate volume, try not to turn on the maximum, so as not to damage the hearing.
- Earplug cover cleaning, healthy, comfortable earplug cover need to be cleaned regularly, keep clean.
Musical pattern
Play: Press 1 touch area
Pause: Press 1 touch area
Switch songs: Press the touch area twice
Switch songs: Press the touch area 3 times
Telephone mode
Answer: Press the touch area once
Call rejection: Press the touch area twice
Hang up: Press the touch area twice
Product parameter
Working range :10m
Charging current: 0.3A
Charging voltage: 3.7V
Impedance :32 ohm
Charging time: 1-1.5H
Frequency response :20-20KHz
sensitivity: 112+/-3dB
FCC STATEMENT
-
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation. -
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules, These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications, However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the Consult the dealer or an experienced radio/TV technician for help.
RF warning statement
The device has been evaluated to meet general RF exposure requirement, The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>