Linklike LNTW1 LinkPods Deep Bass Wireless Earbuds User Manual

Linklike LNTW1 LinkPods Deep Bass Wireless Earbuds

Specifications

• Model: [Product Model]
• Transmitter Type: [Transmitter Type]
• Operating Frequency: [Operating Frequency]
• RF Radiation Exposure Limits: Complies with limits for an  uncontrolled environment
• Minimum Distance: 5mm between the radiator and your body

Product Usage Instructions

Installation

To ensure proper installation of the [Product Model], follow these steps:

1. Select a suitable location for the transmitter.
2. Ensure that the transmitter is not co-located or operating with any other antenna or transmitter.
3. Place the transmitter with a minimum distance of 5mm between the radiator and your body.

Operation

To operate the [Product Model], please adhere to the following  guidelines:

1. Make sure that the transmitter is properly installed as per the installation instructions.
2. Connect the necessary power supply or batteries to the transmitter.
3. Follow any additional instructions provided in the user manual for specific functions or features.

Maintenance

To maintain the [Product Model] and ensure its longevity, consider the following:

• Regularly clean the exterior of the transmitter using a soft, dry cloth.
• Avoid exposing the transmitter to extreme temperatures or humidity.
• Keep the transmitter away from water or other liquids.

CHARGING INSTRUCTIONS

ATTENTION
Important Notes: Please keep it for future reference

1. This product must not be cleaned with corrosive cleansers.
2. Please do not use this product in hot or humid environments and do not allow it to be heated, near a source of ignition, or in a fire to avoid explosion.
3. No component suitable for self-maintenance by users is applied in this product, so please do not disassemble or refit it by yourself.
4. If this product is to idle for a long time, please store the earbuds in the charging case ensure a dry storage environment, and make the charging case charged at least once each month.
5. Please do not charge this product in temperatures below zero, as this will damage the battery.
6. Please do not use this product in thunderstorms as this may cause the earbuds to work improperly and increase the risk of electric shock.
7. Please adjust the system volume to a moderate level, for an excessive volume would incur a higher risk of hearing damage.
8. Please don’t use this product in circumstances where special attentions are required (i.e. when in traffic or engaged in skilled work).
9. When using the charger for power supply, please purchase or use a charger that has obtained certification and meets the standard requirements.
10. In order not to facilitate the normal use of this product, please use a USB-C charging adapter that meets national standards.
11. Please keep the product accessories and packaging parts out of the reach of children and pets to avoid accidents and choking hazards.

BATTERY WARNINGS

This product is equipped with a built-in lithium battery, please pay attention to the following:

1. Please charge the product in a time when the battery is low. To protect the battery when not in use for a long time, please turn on the product every 3 months until the battery power runs out and then fully charge the product. It is recommended to use and store it in a suitable environment.
2. It is forbidden to disassemble, hit, squeeze, or throw it into fire. If severe swelling occurs, stop using it. Do not place it in a high temperature environment. If the battery life is seriously shortened, stop using it and handle it for professional maintenance.
3. There is a risk of explosion if the battery is improperly replaced, and it can only be replaced with a battery of the same or equivalent type by a professional.
4. The battery (battery pack or assembled battery) shall not be exposed to overheated environments such as sunlight or fire.
5. Products containing lithium batteries should be handled separately from household waste. If the product is disposed of, it is necessary to remove the battery and insulate the positive and negative ends and put it into the designated recycling locations or hand it over to the environmental protection recycling department for disposal, and cannot discard it at will.
6. Steps for disassembling the battery: D Disassemble this product and take out the PCB and battery pack; 2 Unscrew the screws in sequence with a screwdriver; 3 Separate the battery, PCB, and shell. The battery may be taken out by cutting off the connecting line between the battery and the PCB  (Special warning: Do not cut off all the cables between the battery and the circuit board at the same time.)

WEARING INSTRUCTIONS

Choosing the right earbud cap and wearing it correctly will enhance the wearing and noise cancellation experience.

Note : Please clean the earbuds regularly to keep them clean.

PAIRING AND CONNECTION

• Open the case and take out the earbuds, the earbuds will flash white light slowly and enter the pairing model. Click the “LINKLIKE
• Halo” in bluetooth interface on the device to connect.

OPERATING INSTRUCTIONS

Note : Manual power on-press the function area for 3s; Manual power off- press the function area for 6s (The music and call mode can not be turned off) The music function corresponds to the music mode, and the call function corresponds to the call mode.

OTHER INSTRUCTION

• Power volume display
  For different mobile phone systems, you can check the earbud’s power volume on the negative screen, drop-down box, and top notification bar of the mobile phone.

• Volume sync help
  If your phone is not iOS, after the earbuds connection:

• Settings-Bluetooth -Earbuds Settings-Turn on volume synchronization;

• Settings -Developer Options-Turn on Bluetooth Absolute

  • Volume; Otherwise, the sound quality experience and volume adjustment function will be affected.
  • Automatic reconnection The earbuds will reconnect to the last device you connect automatically after power on.

Other operations and status descriptions

Fcc Statements

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules.

Operation is subject to the following two conditions

1. this device may not cause harmful interference,
2. this device must accept any interference received, including interference that may cause undesired operation.

FCC RF Radiation Exposure Statement

1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
2. This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
   This equipment should be installed and operated with a minimum distance of 5mm between the radiator and your body.

FAQ

Frequently Asked Questions

• Q: Can I use the [Product Model] with other antennas or transmitters?
  • A: No, the [Product Model] should not be co-located or operated in conjunction with any other antenna or transmitter.
• Q: What are the RF radiation exposure limits for the [Product Model]?
  • A: The [Product Model] complies with RF radiation exposure limits set forth for an uncontrolled environment.
• Q: What is the minimum distance required between the radiator and the body?
  • A: The minimum distance should be 5mm between the radiator and your body.

Linklike (Shenzhen) Technology Co., Ltd.

• ADD: RM1709, BLK C, Zhantao Technology BLDG, Minzhi Avenue, Minzhi ST, Longhua DIST, Shenzhen, China
• E-mail: [email protected]
  Linklike is a trademark registered in the USA and other countries. All rights reserved. Made in China

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>