HMmagnets 12 Magnetic Knife Holder for Fridge Double Sided User Guide

HMmagnets 12 Magnetic Knife Holder for Fridge Double Sided

Parts

Note: Fridge mounting instructions are on the back side of this paper.

Parts needed for drill mounting installation:

1x

| | One stainless steel magnetic knife bar+ one carton stencil for holes
---|---|---

1x

| | Two screws (3.9 X 40 mm)+ two screw anchors (6 X 30 mm)

1x

| | Spare set of two screws and two anchors

MARKING DOTS BEFORE DRILLING

STEP 1: MARKING DOTS BEFORE DRILLING

Use stencil to mark two small dots for intended placement.

• The distance between the center of the two dots should be 8″ (20.32 CM).
• Install the bar horizontally, use of a level is recommended.
  

STEP 2: DRILL TWO HOLES ON THE MARKED DOTS THE SAME SIZE AS THE ANCHORS

Important Tip: Drill only one hole first. Then, using the stencil, check that the second hole is where it should be

1. Install the screw anchors into the holes. To prevent the bar from wiggling, make sure the anchors are flush with the wall.
   

2. Install the screws into the anchors, leaving only the head exposed .

STEP 3: PLACE THE MAGNETIC STRIP OVER THE SCREWS

1. Place the magnetic strip over the screws.
2. Once on, slowly and carefully, press the magnetic bar down so the screw heads lock into the narrow part of the holes.
3. Once finished, if the magnetic bar is loose or wobbly, please make sure the screw anchors are all the way in and that the screw heads are the only parts visible. You can try screwing the screws in a little deeper and attaching the bar again and repeat, if necessary, until the bar is securely placed.
   

PROPER USE & WARNINGS

• The bar should be installed horizontally. Knife blades should point up.
• Recommended placement – above a hard surface (i.e. kitchen counter).
• Keep away from children.
• Pacemakers may be affected by the magnet. Keep a distance of at least 6 inches from the magnetic bar.
  

FRIDGE MOUNTING 12″ VERSION

Note: Drilling mounting instructions are on the back side of this paper.

A) IMPORTANT NOTES BEFORE MOUNTING:

1. WATCH YOUR FINGERS – the knife holder has powerful magnetic force. Watch your fingers when you place the bar on the side of your fridge.
2. Make sure the side of your fridge is 100% flat and without any bumps.
3. The bar should be installed horizontally and the knives should be placed vertically.
4. We recommend placing the bar only on the side of your refrigerator, and not on its door.
5. Choose a high enough position so it will be out of children’s reach.
6. How to prevent scratching your fridge – DO NOT slide the bar when trying to correct its position or when removing the bar. Instead, in order to remove the bar, hold one end of the bar and detach the other end (see illustration below). This will minimize the scratches on the side of your fridge.
7. Pacemakers may be affected by the magnet. Keep a distance of at least 6 inches from the magnet bar.

B) MOUNTING

Step 1: Hold the bar with both of your hands. Make sure ALL of your fingertips are NOT placed on the back
side of the bar, to prevent them from being caught between the bar and the fridge.

Step 2: Carefully place the bar on your fridge. You can start from one side and then slowly attach the other side. Again, be careful with your fingers and make sure they are not in the way!

C) FUTURE REMOVAL

After the bar is placed, it will take quite a bit of force to move it or lift it off. We recommended holding one end of it and detaching the other end.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>