PPLEE CR01001E Digital Dual Alarm Clock for Bedroom User Manual

PPLEE CR01001E Digital Dual Alarm Clock for Bedroom User Manual

LOCATION OF CONTROLS

1. Set Time Button
2. Hour Button
3. Minute Button
4. Dimmer Button
5. SNOOZE Button
6. Alarm Pause Button
7. Alarm OFF Button
8. Alarm 1 Button
9. Alarm 2 Button
10. PM Indicator
11. Alarm 1 Indicator
12. Alarm 2 Indicator
13. DST Indicator
14. 12/24H & DST Button
15. Volume + Button
16. Volume – Button
17. Battery Compartment
18. USB Port
19. DC Jack
20. Speaker
21. Holder (x 2pcs)

POWER RESOURCES

1. Install 2pcs 1.5V “AAA” size batteries to the proper terminals in the battery compartment to memorize the time setting in case of power outage.
   NOTE: Batteries (not included) don’t support time display but can memorize time & alarm setting and trigger an alarm in case of AC power failure.

2. Connect the adapter line to DC jack, then plug into a 100~240V AC wall power outlet

TIME SETTING

1. Press button once, display starts flashing.
2. Press button to set the hour. press button to set the minute.
3. Press button or button to save time or wait OK for 5 seconds to confirm automatically.
4. To change 12H/24H time format
   Press button to change 12H/24H time format

ALARM SETTING

1. Press button, the alarm indicator (11) will light up, the display starts flickering.
2. Press button to set the hour, press button to set the minute.
3. Press button or  button to save alarm time or OK just wait for another 5 seconds to confirm automatically.
4. Push or button to adjust alarm volume.
   Setting ALARM 2 is the same as ALARM 1.

Turn off Alarm

When alarm goes off:

1. Press  button to pause the alarm, alarm will ring OK every 9 minutes.

2. Press button to turn off the alarm for today.
   The alarm indicator  or is still on, which means alarm is still activated and will ring after 24 hours.

3. Cancel Alarm
   Press button to turn off alarm 1 or alarm 2 permanently. And corresponding indicator or will disappear Alarm 1 will turn off permanently if you press when Alarm 1 goes off. Similarly, Alarm 2 will turn off permanently if you press (ALARM button when Alarm 2 goes button off

DIMMER

Repeatedly press DIMMER button to adjust the brightness of display for your preference.
There is 5 levels, The sequence is as follows: 01-02-03-04-05-04-03-02-01……..

DST

Hold press button to switch to DST format.
DST indicator will turn on.

Hold press button again to turn off DST function.
DST indicator will be off

USB CHARGING

Plug charging cable into device such as phone or tablet.
Device can charge your phone or tablet at the same time.
The maximum charge current is 1 Ampere.

Contact our expert: support@pplee.net

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>