HEWI M9500 Modular Patient Monitor Instruction Manual
- June 2, 2024
- HEWI
Table of Contents
HEWI M9500 Modular Patient Monitor
User information
Exclusion of liability
HEWI accepts no liability whatsoever for damage to persons or property that
occurs or has occurred as a result of improper mounting or maintenance,
particularly if the safety instructions and other points to note listed are
not or have not been observed in full. HEWI accepts no liability whatsoever
for damage occurring from incorrect cleaning.
Safety instructions
Mounting only by authorised qualified electricians and in compliance with the
applicable regulations, especially regulation VDE 0100, Part 701 or the
respective national regulations.
Failure to comply voids warranty and liability obligation.
Following installation, the instructions must be made available to the user.
- Follow with the installation instructions and instructions for use.
- In case of questions, problems, uncertainties or if damage occurs, contact the HEWI support service.
- Ensure that the product is installed, maintained and repaired by qualified, skilled personnel only.
- Check the product for damage on acceptance.
- Port defects immediately.
- Install/use the product only:
- in accordance with its intended purpose
- in its original condition without modifications
- in perfect condition
- Use original spare parts only.
- Use only HEWI fixing materials.
- Only use in closed rooms.
Care and cleaning
Cleaning
CAUTION!
Improper cleaning can cause damage to the surface and lead to injuries.
- Clean the product as and when required.
- Follow the manufacturer’s instructions regarding concentration, contact time, etc.
- Always apply the cleaning product on a cloth; do not apply it directly on the surface.
- Rinse with cold water immediately after cleaning.
- Note the material-specific information on suitable/unsuitable cleaning products.
- Try out all products on an inconspicuous area before use.
- Do not use any products of unknown composition.
- Clean mirror with soft, dry cloth; use damp leather to remove stubborn stains.
Unsuitable cleaning products
- Abrasive products/objects (e.g. scouring agents, scourer sponge, brushes, steel wool, microfibres, dirt erasers)
- Alkaline, acidic and chlorine-based cleaning products, solvents
- Steam cleaners
- Do not treat metal components with objects containing iron (e.g. scourer sponge, steel wool).
Disposal
The disposal of the product and packaging is subject to the relevant national regulations.
- Do not dispose of the product in the household waste.
- After the end of the service life, the product (including lamps) must be disposed of properly.
- Hand lamps to the municipal waste disposal company (e.g. recycling centre).
- Sort packaging before disposal.
- Further information on disposal can be obtained from your local authority.
LED not replaceable
The light source of the mirror cannot be replaced. When the LED lights have reached their end of life, replace the entire mirror unit.
Product information
Tools required
Technical data
Mains supply|
200 – 240 V~
---|---
Mains frequency|
50 Hz
Secondary side|
950.01.11101
12 V DC – 1 x 12W
|
950.01.3010
12 V DC – 1 x 10W
Protection type|
IP44
Protection class|
Installation site|
Enclosed rooms
The light source included in this product is energy efficiency grade G.
Mounting information
WARNING!
Risk of injury from electric shock
Have product connected by a qualified electrician. Disconnect from power
supply before installing.
Mounting
Demounting
Customer Support
GERMANY
HEWI Heinrich Wilke GmbH
Prof.-Bier-Straße 1-5
D-34442 Bad Arolsen
Phone: +49 5691 82-0
Fax: +49 5691 82-319
international@hewi.de
UNITED KINGDOM
HEWI (UK) Limited
Holm Oak Barn, Beluncle Halt
Stoke Road, Hoo
Rochester, Kent ME3 9NT
info@hewi.co.uk
www.hewi.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>