M100 OBD App User Manual
- June 4, 2024
- APPs
Table of Contents
M100 OBD App
Product Description
This product can read vehicle information and diagnose the health of the vehicle, including fault codes, freeze frames, MIL status, etc.; it can also read engine data, including engine speed, coolant temperature, etc.
Find the OBD interface
Find the OBD port in the car. The OBD interface of different models may be located in diferent positions. (Generally located under the dashboard on the driver’s side of the car, above the accelerator pedal)
Download APP
IOS users can also search for M100 in the App Store to download
APP connection
- Turn on the phone’s Bluetooth
- Enter the APP
- Select VCI
- Enter the Bluetooth connection state and select “NEXTLINK” for Bluetooth connection
-
Select any detection function to connect the car ECU
-
After the ECU is successfully connected, the test result will be displayed
- If the product is compatible with the car, the connection can be successful
- If the connection is abnormal, you can turn off the car and re-plug the product to try to connect
Icon introduction
Warning Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- (1) This device may not cause harmful interference
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.