WS DBL-02 Wall Mounted Wash Basin Mixer + Trim Installation Guide
- May 15, 2024
- WS
Table of Contents
WS DBL-02 Wall Mounted Wash Basin Mixer + Trim
Product information
Specifications
- Max working pressure: 5 bar
- Min Working Pressure: 0.5 bar
- Recommended pressure: 2/3 bar
- Water Test Pressure: Max 10 bar
Product Composition
This product is composed of high-quality materials including microfiber and water-resistant components.
Product Usage Instructions
Installation
- Fix the Trim to the wall, ensuring it is level.
Leakage Test Advice
- For higher pressure, mount a pressure-reducing valve.
- Open the taps to release air before conducting the water test to avoid compression in pipes.
Maintenance Tips
- Avoid using acidic or grainy detergents and rough sponges on chromed surfaces.
- Clean taps with water and soap or specific products for chromed surfaces.
- Rinse thoroughly with running water and dry with a soft cloth.
FAQs (Frequently Asked Questions)
Q: How should I clean the taps to remove dirt and limescale stains?
- A: Clean the taps with water and soap or specific products for chromed surfaces. Rinse thoroughly with running water and dry with a soft cloth.
Q: What should I do before conducting a leakage test?
- A: Ensure that for higher pressure, a pressure-reducing valve is mounted. Open the taps to release air before conducting the water test to avoid compression in pipes.
PRODUCT COMPOSITION
VERY IMPORTANT ADVICE FOR LEAKAGE TEST
- MAX working pressure: 5 bar // MIN working pressure: 0.5 bar // Recommended pressure: 2/3 bar Water test of plumbing system: MAX 10 bar (with gradual water pressure increase).
- MAX working temperature: 60°C
- For higher pressure mount a pressure-reducing valve. To avoid overload, the taps must be first opened so the air can go out, then closed for the water test.
- (otherwise, the air is compressed in the pipes and it is not possible to know the value of the max allowed pressure).
- Always perform an installation test correctly. Check the correct mass energy dispersion (e.g for whirLpool bathtub system). Dispersion of electricity could be the cause of corrosion.
To preserve the beauty and shine of the taps for a long time, the following rules must be observed:
- The chromed surfaces are easily attacked by acidic and grainy detergents, rough sponges and metal scouring pads are not recommended.
- To remove dirt and limescale stains, simply clean the taps with water and soap; or by using specific products for chromed surfaces. Rinse thoroughly with running water and dry the parts with a dry cloth.
MOUNTING INSTRUCTIONS
Wall-mounted washbasin mixer + Trim
The images presented in these instructions are purely explanatory. Your
product may be aesthetically different from what is shown, but these
instructions are still valid for the correct assembly
Dimension
- Fix the Trim to the wall, checking that it is level.
INSTALLATION INSTRUCTION
-
Check the parameters and the level of the fastening to the wall.
-
Wall finish MAX
-
Wheelbase 125mm
-
Remove the screw, the plastic protection from the mixer, and the cap from the G1/2 F outlet
-
Insert the finishing cover cylinder
-
Screw on the locking cap in finish
-
Assemble the chosen barrel in the G1/2 thread (the model may change according to the aesthetics).
If the spout fitting is separate, first assemble the fitting by interposing Teflon tape to ensure the seal between the male and female threads. -
Depending on the chosen product, insert the single plate or the two single plates in the appropriate locations. If present, insert the centering plate.
-
Depending on the chosen product, connect or screw the mouth. Then secure the fitting with the screws (or already complete with G 1/2 male welded fitting)
-
Insert the lever on the cartridge and fix it with the hexagonal head screw.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>