WS Lighting WS-S06D LED Wall lamp Plug in Cord Bedside Reading Light User Manual
- June 16, 2024
- WS Lighting
Table of Contents
WS-S06D
WS-S06D LED Wall lamp Plug in Cord Bedside Reading Light
WS-S06D
V1.0
INSTALLATIONINSTRUCTION
Double light source ……………..Reading Wall
| Finsh | Material |
|---|---|
| Matte | Black |
TECHNICAL CHARACTERISTICS
Lightsource: LED
Input:100~277V 50/60Hz
Output(W): Spotlight 3W
Background light 10W
Warm Tips
- Please read the instructions carefully before commencing assembly.
- The installation of luminaire should be undertaken with utmost care and a qualified electrician should carry out the work to ensure compliance with any local wiring regulations.
- Always ensure that the mains electrical supply is disconnected before installing luminaire.
- Ensure the light source is compatible with local voltage and follow any maximum wattage instructions shown on the product itself.
- Live: Black
Neutral: White
Earth: Normally Green /Bare copper
Option 1 
Option 2
FCC Statement
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Atncrease the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>