KUNA KNA-CP02-BK-01 Camera Porch Light Instruction Manual
- June 4, 2024
- KUNA
Table of Contents
KUNA KNA-CP02-BK-01 Camera Porch Light
PACKAGE CONTENTS
SAFETY INFORMATION
WARNING
- Risk of fire or electric shock. 120V light installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt to install. Contact a qualified electrician.
- Disconnect power at fuse or circuit breaker before installing or servicing.
- No user serviceable parts inside. To avoid electrical shock, do not disassemble product.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- Use only on 120V AC, 60 Hz circuits, and with maximum 60W light bulb.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Please read and understand this entire manual before attempting to assemble,
install, or operate this light fixture. Your government may regulate the use
of security cameras and other recording devices. It is the purchaser’s sole
responsibility to ensure compliance with all applicable laws and to provide
any legally required notices. Check local laws regulating the use of any
recording devices and cameras prior to installation.
NOTE
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced technician for help.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare
parts with package contents list. If any part is missing or damaged, do not
attempt to assemble the product.
Tools needed:
- Phillips screwdriver
- Step ladder
- Silicone sealant (optional)
INSTALLATION
Disconnect power at fuse or circuit breaker before installing the light.
Ensure fixture screws and nuts are inserted into the bracket as shown. Adjust
the swivel angle based on your junction box. 
Tighten middle screws in the bracket so
it’s firm and doesn’t wobble. Fasten bracket to junction box using 2 junction
box screws. Choose short or long as needed. 
Use the screw length indicator to adjust the length
of the two long screws. Then, tighten the two nuts. 
Use the holding hook to suspend the
light fixture and free up both hands for wiring. Connect the bottom of the
hook (square) to the right screw pole. Hang the top of the hook onto the
mounting bracket. 
Use wire nuts to connect black wires together.
Insert both wires all the way into the nut and twist until secure. Then repeat
for the white wires and for the ground wires. Wall wire colors may vary.
Recommended: Use of a voltage detector to confirm the power is off.
Holding
light fixture with both hands, align the two fixture long screws into the
light fixture screw posts.
Mount light fixture to long screws as shown, then
install both decorative nuts. Install a light bulb (maximum wattage: 60W).
Apply silicone sealant between wall and light fixture (optional). Reconnect
power at fuse or circuit breaker after installing the light.
Adjust
the angle of the camera lens, loosening up the locking ring. Use two fingers
and turn it counter-clockwise. Lock it back up by turning the locking ring
clockwise. For final adjustment, see the video feed on the phone after
downloading the app and setting up WiFi.
WiFi Setup
After installation, on your iOS or Android smartphone, please visit getkuna.com/app to download and install our free Kuna App. Follow in-app instructions to set up your Kuna Camera Porch Light.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>