Marshall MINORIII True Wireless Headphones User Guide
- June 6, 2024
- Marshall
Table of Contents
MINOR III – TRUE WIRELESS
QUICK START GUIDE
GETTING STARTED
- Open the charging case.
- Press and hold the button on the bottom of the case until the LED turns blinking blue.
- Select MINOR III from your sound device’s Bluetooth ® list.
Marshall is a trademark of Marshall Amplification Plc. Permission granted.
Design of product and packaging are intellectual properties of Zound
Industries International AB, Centralplan 15 111 20 Stockholm, Sweden.
© Zound Industries International AB. All Rights Reserved.
The Bluetooth® wordmark and logos are registered trademarks owned by the
Bluetooth SIG, Inc. and any use of such marks by Zound Industries
International AB is under license. R0.8
TOUCH CONTROLS
Touch the left or right earbud to control your music and phone calls.
- 1 touch to play/pause or receive/end a call
- 2 touches to skip forward or reject a call
- 3 touches to skip backward
CHARGING CASE
Put your earbuds back in the case and close the lid to turn them off and begin charging. The case is charged by placing it on a wireless charger or plugging it into a USB power source.
LED INDICATOR
The LED shows the case battery charge, from red through yellow to green (0–100%). It blinks blue while in Bluetooth pairing mode.
BLUETOOTH PAIRING BUTTON
Place the earbuds in the case and keep the lid open. Press and hold the Bluetooth pairing button until the front-facing LED starts blinking blue to set the earbuds in pairing mode.
IMPORTANT SAFETY INSTRUCTIONS
Not suitable for children under age three.
Contains small parts, which may be a choking hazard.
Long-term exposure to loud music or sounds may cause
hearing loss. To prevent possible hearing damage, do not listen at high volume
levels for long periods.
Electrical products, cables, batteries, packaging, and the manual, should not
be mixed with general household waste. For proper recycling, please take these
products to a designated collection point where they will be accepted free of
charge or return them to your local retailer. Correct product disposal saves
resources and prevents negative effects on human health and the environment.
DC Voltage
To prevent possible harm to the environment or human health from uncontrolled
waste disposal, dispose of the defective rechargeable batteries at special
collection points or return them to your specialist dealer.
WARNINGS
- Set your sound source to low volume before using the headphones.
- Do not use these headphones when operating a motor vehicle, a bicycle, machinery or where your inability to hear outside sounds may present a danger to you or others.
- Using these headphones limits your ability to hear noises around you, regardless of listening volume.
- Keep away from fire, water, and high voltage equipment.
- Do not modify, disassemble, open, drop, crush, puncture, or shred these headphones.
- Do not heat above 113°F (45 °C).
- Do not short-circuit the internal battery or its cells.
- In the event of cell leakage, do not allow the liquid to come in contact with the skin or the eyes.
- The internal battery is not end-user replaceable.
- Only use the included charging case with the Minor III earbuds.
Don’t dispose of a battery into fire or a hot oven, or mechanically crushing
or cutting of a Battery. Don’t leave a battery in an extremely high
temperature surrounding environment To avoid battery subjected to extremely
low air pressure.
Do not ingest battery, Chemical Burn Hazard.This product contains a button
cell battery. If the button cell battery is swallowed, it can cause severe
internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and
keep it away from children.
If you think batteries might have been swallowed or placed inside any part of
the body, seek immediate medical attention.
LEGAL NOTICE
Design of device and packaging are intellectual properties of Zound Industries
International AB. © All Rights Reserved.
MARSHALL, Marshall Amps, their respective logos, “Marshall” and “Marshall”
trade dress are trademarks and intellectual property of Marshall Amplification
Plc and may not be used without permission. Permission granted to Zound
Industries International AB.
The Bluetooth® wordmark and logos are registered trademarks owned by the
Bluetooth SIG, Inc. and any use of such marks by Zound Industries is under
license.
Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its
subsidiaries.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United
States and other countries. aptX is a trademark of Qualcomm Technologies
International, Ltd., registered in the United States and other countries.
All other trademarks are the property of their respective owners and may not
be used without permission.
For more legal information related to this product and to its use in your
specific region, and for more detailed information about Zound Industries and
partner & license information, please visit the website:
www.marshallheadphones.com.
The user is recommended to visit the website regularly for up-to-date
information.
Zound Industries International AB, Centralplan 15, 111 20 Stockholm, Sweden
FCC STATEMENT
WARNING: Any changes or modifications to this device not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This equipment
complies with the FCC radiation exposure limits set forth for an uncontrolled
environment. This device must not be co-located or operated in conjunction
with any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Zound Industries International AB
True wireless headphones / MINORIII
Zound Industries International AB / China
Refer to the date code sticker on the bottom of this product
R-C-Date-MINORIII
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
U.S. responsible party, contact information:
Zound Industries USA, Inc.
260 W 39th Street Suite 1101, New York, NY 10018, USA
Telephone number: 646-214-1003
IC STATEMENT
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the
device.
This Class B digital device complies with Canadian ICES-003.
CAN ICES-003 (B)/NMB-003(B)
DISCLAIMER
Stated playtime is calculated using a random selection of music, played at
medium volume. The information contained herein is correct at the time of
publication, with reservation for editorial errors. This product is software-
dependent and its functions and compatibility can change when updating the
software.
Hereby, Zound Industries International AB, declares that this product is in
compliance with 2014/53/EU.
Maximum RF transmit power: < 20 dBm
For the declaration of conformity, please visit the following website:
www.marshallheadphones.com/doc
Designed in Stockholm
Produced in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>