Secur SP-1103 LED Lantern and Flashlight Instruction Manual

: May 15, 2024
: Secur

Table of Contents

SP-1103 LED Lantern and Flashlight
Product Features and Functions:
Operating Instructions:
Charging the Battery:
Technical Specifications:
Precautions:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LED LANTERN & FLASHLIGHT
Model SP-1103

SP-1103 LED Lantern and Flashlight

General Description: This LED lantern and flashlight collapses for easy storage. Can be charged via the built-in hand crank generator or external USB power source. Also charges cell phones, iPods and other digital devices.

Product Features and Functions:

LED flashlight/lantern — never needs bulbs
High and low power settings
Hand crank charger — never needs batteries
Can be charged via external USB power source
Charges cell phones and other digital devices
Collapsible for easy storage
Hanging ring

Secur SP 1103 LED Lantern and Flashlight - Fig

Operating Instructions:

Lighting: Push the ON/OFF switch once for low power — twice for high power — three times to turn the light off. To use as a flashlight, leave the lantern collapsed. To use as a lantern, first open the black DC power cover (this lets air in and out) and then pull the lampshade open by pulling evenly on both halves of the lantern until fully expanded.

Charging the Battery:

Hand Crank: To charge the battery via the built-in hand crank, first collapse the lantern. Next, unlock and open the hand crank at the bot-tom of the lantern. Turn clockwise at about 3 revolutions per second. Charge for a minute or more and the light will work. The red charging light will glow while charging.
External USB Power Source: To charge with a USB power source such as a computer, 12 volt USB D/C power adaptor, 120 volt USB power adaptor or external Secur solar panel, plug the large male USB plug of the included USB cable into the female USB plug of your power source. Plug the round pin on the other end of the cable into the D/C charging port on the side of the lantern behind the dark cover piece. The red charging light will glow while charging.

Technical Specifications:

The Max. luminous flux of high level lighting as flashlight	65 Lm
The Max. luminous flux of low level lighting as flashlight	15 Lm
The Max. luminous flux of high level lighting as camping lantem	63 Lm
The Max. luminous flux of low level lighting as camping lantem	15 Lm
Fully charged time	4 Hours
High level lighting time after 1 minute cranking	4 Minutes
Low level lighting time after 1 minute cranking	11 Minutes
High level lighting time after being charged fully	40 Minutes
Low level lighting time after being charged fully	45 Hours

Note: Lighting time testing standard is brightness down to 5% of open time’s brightness.
Charging the Battery:

Specification of charge connector	DC connector, Φ3.5XΦ1.3mm
Input voltage	5±0.2V

Lifespan:

The whole unit	≥5 Years
The plastic part	≥5 Years

Size and Weight:

Product size| Expanded: 4.5″ X 3.5″
Collapsed: 2.0″ X 3.5″
---|---
Product weight| 7.0 ounces

Others:

Specification of built-in battery| 300mAh/3.7V capacitance type lithium battery
---|---

Charging Digital Devices: To charge cell phones, iPods or other digital devices, first collapse and close the lantern. Use the included female USB cable and plug the round pin at one end of the cable into the DC port on the side of the lantern behind the black cover. Use your standard USB charging cable and plug the large male USB plug into the large female USB port at the other end of the charging cable. With your device connected, turn the built-in hand crank steadily clockwise at about 3 revolutions per second. Your device will continue to charge as long as you continue to crank.

Precautions:

To avoid injury, never shine the light directly in the eyes.
Crank as evenly as possible and keep rotating steadily. Cranking too slowly will increase the charging time, cranking too quickly can damage the power generator.
Be careful when cranking to avoid injury to fingers and fingernails
To increase the lifespan of the battery, do not crank continuously for more than 3 minutes when the flashlight can light normally — and do not crank more than 10 minutes continuously when it can’t light.
Cranking the handle at least 1 minute once a month will prolong the life of battery.

Included Accessories: