Bomar P2000-25 Hatches and Ports User Guide
- May 15, 2024
- Bomar
Table of Contents
Bomar P2000-25 Hatches and Ports User Guide
- Pull out all old gasket.
- Starting near a hinge, gently push the lip of the gasket into the space between the lens and extrusion.
- Carefully cut gasket to length forming a butt joint.
- Pull out two inches of gasket either side of joint. Superglue joint together. Be careful not to get superglue on the lens. Allow glue to set for five minutes.
- Push gasket joint into cavity.
- Apply a drop of glue in four corners as shown in the diagram below. (the gasket shown below is for demonstration, it does not represent all gaskets)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>