SONY WH-CH720N Wireless Noise Canceling Stereo Headset User Manual
- June 9, 2024
- Sony
Table of Contents
WH-CH720N Wireless Noise Canceling Stereo Headset
User Manual
WH-CH720N Wireless Noise Canceling Stereo Headset
Wireless Noise Canceling Stereo Headset
Model: YY2966
The term “product” in this document refers to the unit or its accessories.
Without permission granted by the NCC, no company, enterprise, or user shall
change frequency, enhance transmitting power or alter original characteristics
as well as performance of approved low power radio-frequency devices.
The low power radio-frequency devices shall not influence aircraft security
nor interfere with legal communications; If found, the user shall cease
operating immediately until no interference is achieved.
The said legal communications refers to radio communications operated in
compliance with the Telecommunications Management Act. The low power radio-
frequency devices must endure interference from legal communications or ISM
radio wave radiated devices.
Do not install the product in a confined space, such as a bookcase or built-in
cabinet.
Do not expose the batteries (battery pack or batteries installed) to excessive
heat, such as sunshine, fire or the like, for a long time.
Do not subject the batteries to extreme low temperature conditions that may
result in overheating and thermal runaway.
Do not dismantle, open, or shred secondary batteries.
In the event of a secondary battery leaking, do not allow the liquid to come
in contact with the skin or eyes. If contact has been made, wash the affected
area with copious amounts of water and seek medical advice.
Secondary batteries need to be charged before use. Always refer to the
manufacturer’s instructions or product manual for proper charging
instructions.
After extended periods of storage, it may be necessary to charge and discharge
the secondary batteries several times to obtain maximum performance.
Dispose of properly.
This unit has been tested and found to comply with the limits set out in the
EMC regulation using a connection cable shorter than 3 m.
Do not use, store, or leave in a place subject to high amounts of humidity,
dust, smoke, or steam, or in a place subject to high temperatures, such as
near a fire or a location subject to direct sunlight, such as in a car.
High volume may adversely affect your hearing.
Do not use the unit while walking, driving, or cycling. Doing so may cause
traffic accidents.
Do not use in hazardous areas unless the surrounding sound can be heard.
The unit is not waterproof. If water or foreign matter enters the unit, it may
result in fire or electric shock. If water or foreign matter enters the unit,
stop use immediately and consult your nearest Sony dealer. In particular, be
careful in the following cases.
-
When using the unit near a sink or liquid container
Be careful that the unit does not fall into a sink or container filled with water. -
When using the unit in the rain or snow, or in humid locations
-
When using the unit while you are perspiring
If you touch the unit with wet hands, or put the unit in the pocket of a damp
article of clothing, the unit may get wet.
For details on the effects of contact with the human body from the mobile
phone or other wireless devices connected to the unit, refer to the
instruction manual of the wireless device.
Never insert the USB plug when the unit or charging cable is wet. If the USB
plug is inserted while the unit or charging cable is wet, a short circuit may
occur due to liquid (tap water, seawater, soft drink, etc.) or foreign matter
on the unit or charging cable, and cause abnormal heat generation or
malfunction.
This product has magnet(s) which may interfere with pacemakers, programmable
shunt valves for hydrocephalus treatment, or other medical devices. Do not
place this product close to persons who use such medical devices. Consult
your doctor before using this product if you use any such medical device.
This product has magnets. Placing magnetic stripe cards in the vicinity of the
product may affect the magnetism of the card and render it unusable.
Note about static electricity
If you use the unit when the air is dry, you may experience discomfort due to
static electricity accumulated on your body. This is not a malfunction of the
unit. You can reduce the effect by wearing clothes made of natural materials
that do not easily generate static electricity.
Complies with IMDA Standards DB00353
Precautions
The two-dimensional code or the URL on the cover will help you access the help guide that describes useful notes or procedures in details.
On BLUETOOTH® communications
- Microwaves emitting from a Bluetooth device may affect the operation of electronic medical devices. Turn off this unit and other Bluetooth devices in the following locations, as it may cause an accident:
– in hospitals, near priority seating in trains, locations where inflammable gas is present, near automatic doors, or near fire alarms.
On charging the unit
- Be sure to use the supplied USB Type-C cable.
Notes on wearing the unit
- Because the headphones achieve a tight seal over the ears, forcibly pressing them against your ears or quickly pulling them off can result in eardrum damage. When wearing the headphones, the speaker diaphragm may produce a click sound. This is not a malfunction.
Other notes
- When you use the unit as wired headphones, use the supplied headphone cable only. Make sure that the headphone cable is firmly inserted.
- Do not apply weight or pressure to the unit for long periods, including when it is stored, as it may cause deformation.
- If you experience discomfort while using the unit, stop using it immediately.
- If you have any questions or problems concerning this unit that are not covered in this manual, please consult your nearest Sony dealer.
Location of the serial number label
See Fig. A
Specifications
Headset
Power source:
DC 3.85 V: Built-in lithium-ion rechargeable battery
DC 5 V: When charged using USB
Operating temperature:
0 °C to 40 °C
Rated power consumption:
3 W
Mass:
Approx. 192 g
Impedance:
325 Ω (1 kHz) (when connecting via the headphone cable with the unit turned
on) 31 Ω (1 kHz) (when connecting via the headphone cable with the unit turned
off)
Sensitivity:
108 dB/mW (when connecting via the headphone cable with the unit turned on) 99
dB/mW (when connecting via the headphone cable with the unit turned off)
Frequency response:
7 Hz – 20 000 Hz (JEITA) (when connecting via the headphone cable with the
unit turned on)
Included items:
Wireless Noise Canceling Stereo Headset (1) USB Type-C ® cable (USB-A to USB-C
® ) (approx. 20 cm) (1)
Headphone cable (approx. 1.2 m) (1)
Communication specification
Communication system:
Bluetooth Specification version 5.2
Output:
Bluetooth Specification Power Class 1
Frequency band:
2.4 GHz band (2.400 0 GHz – 2.483 5 GHz)
Design and specifications are subject to change without notice.
System requirements for battery charge using USB
USB AC adaptor
A commercially available USB AC adaptor capable of supplying an output current
of 0.5 A (500 mA) or more.
Compatible iPhone/iPod models
iPhone SE (3rd generation), iPhone 13 Pro Max,
iPhone 13 Pro, iPhone 13, iPhone 13 mini,
iPhone 12 Pro Max, iPhone 12 Pro, iPhone 12,
iPhone 12 mini, iPhone SE (2nd generation),
iPhone 11 Pro Max, iPhone 11 Pro, iPhone 11,
iPhone XS Max, iPhone XS, iPhone XR, iPhone X,
iPhone 8 Plus, iPhone 8, iPhone 7 Plus, iPhone 7,
iPhone SE, iPhone 6s Plus, iPhone 6s,
iPod touch (7th generation)
(As of May 2022)
Trademarks
-
Apple, iPhone, iPod and iPod touch are
trademarks of Apple Inc., registered in the U.S.
and other countries. -
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Sony Group Corporation and its subsidiaries is under license.
-
USB Type-C® and USB-C® are registered trademarks of USB Implementers Forum.
-
All other trademarks and registered trademarks are trademarks or registered trademarks of their respective holders. In this manual, ™ and ® marks are not specified.
Licenses
-
Use of the Made for Apple badge means that an accessory has been designed to connect specifically to the Apple product(s) identified in the badge, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
-
This product contains software that Sony uses under a licensing agreement with the owner of its copyright. We are obligated to announce the contents of the agreement to customers under requirement by the owner of copyright for the software. Please access the following URL and read the contents of the license.
https://rd1.sony.net/help/mdr/sl/23/ -
Services offered by third parties may be changed, suspended, or terminated without prior notice. Sony does not bear any responsibility in these sorts of situations.
https://rd1.sony.net/help/mdr/2966/h_zz/
©2023 Sony Corporation
Printed in China
https://www.sony.net/
References
- Sony Group Portal - Home
- Help Guide | Top
- Help Guide | Top
- Sony Electronics - Televisions, Audio, Cameras, Mobile, Video Cameras
- Sony Corporation - Home