Dinftin Liftmaster 801CB-P Garage Door Sensor Sun Shield Protector Instruction Manual
- May 15, 2024
- Dinftin
Table of Contents
Dinftin Liftmaster 801CB-P Garage Door Sensor Sun Shield Protector
Instruction Manual
INTRODUCTION
The Garage Door Sensor Sun Shield is a device designed to protect your garage door sensors fromthe harmful effects of the sun’s UV rays. Sensors that are constantly exposed to UV rays maybecome damaged, leading to incorrect or failed sensor readings. The sun shield is easy to install and is an effective way to extend the lifespan of your garage door sensors.
FEATURES
- UV-resistant material blocks harmful sun rays from reaching the sensors.
- Easy to install and remove for seasonal use.
- Lightweight and durable for convenient storage.
- Fits most standard-sized garage door sensors.
INSTALLATION
-
Step 1: Unscrew the wing nut on the sensor and align the pre-drilled hole perfectly with the sensor.
-
Step 2: After alignment, and then tighten the wing nut, the installation is complete.
-
Step 3: It only takes about 30 seconds to install, after which you can try closing the garage door to test the effect of the protector.
USAGE
Simply install the sun shield during periods of intense sunshine, and remove it when not needed(e.g., during winter months). Regularly inspect the condition of the sun shield and replace if necessary
CAUTIONS
- Ensure the sun shield is installed correctly and securely to prevent any accidental falls or damage to the sensors.
- Do not use the sun shield if it is damaged or has tears in it.
- Regularly clean the sensors to remove any dirt or debris that may accumulate over time.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>