10L0L Golf Cart Underglow LED Light Strip Kit with Canopy Lights Installation Guide
- May 15, 2024
- 10L0L
Table of Contents
10L0L Golf Cart Underglow LED Light Strip Kit with Canopy Lights
We are striving to build a reliable brand of golf cart parts and accessories. Hope this manual can assist you to easier installation. For more technical support, please reach us via
- Website: www.10101.com
- Email: sale_service@10l01.com
- Facebook : zhong zaiyang
- Youtube: 10L0L
Contents
Contents/ QTY
- Light Bar ……. …………… ….. .. .. ………. 1
- Control Box ……………………………………. 1
- Wire Harness ……………… ………… ……. 1
- Remote Control ………………………. ….. . 1
- Tape ……………………………………… ……. 1
- Screw ……… ….. ……………… ….. ………. 2
- Small Clip ……………………………………. 10
- Cable Tie ………….. ….. ………………….. 20
What in Box
Installation Tools
- 14mm Wrench ………… ….. .. ….. …….. . 1
Installation Instruction
- Wipe up an area on the battery compartment for placing the control box.
- Place and fix the control box and the area with double-sided tape.
- Place the control box as shown in the picture.
- Wipe up the cart roof.
- Peel off the release paper of the light strip. and then stick the strip on with its terminal part pointing towards the gott cart front.
- Press lhe surface to enhance the adhesion. It will be better if you can use extra tape to hold their ends.
- Finish the part of roof strips.
- Organize the wires with wire organizers.
- Peel of the release paper and stick the organizers in place.
- Hold the wires as shown in the picture.
- Plug the long wire to the socket on the roof.
- Wire down along the golf cart rear frame.
- Zip-tie the wires.
- Zip-tie the v,,.ires of the 4 underglow strips. Wiring Diagram of Golf Cart Ribbon Light Bar.
- Connect all the 5 plugs.
- Connect the light kit to the battery with red ends to the positive ( +) and black ends to the negative(-).
- Tighten the connection with a 14mm wrench.
- Connection complete.
Fantastic Color Light Strip Function Button
- Turn On
- Switching Mode
- Music Mode
- Turn Off
24 Modes Selection:
- Fantastic Color Flow Mode
- Colourful Cyclic Flash Mode
- Colourful Flow Mode
- Fantastic Color Gradient Mode
- Colourful Switching to Flow Mode
- Colourful Cyclic Flow Mode
- Red Gradient Mode
- Blue Gradient Mode
- Green Gradient Mode
- Purple Gradient Mode
- Light Blue Gradient Mode
- Yellow-green Gradient Mode
- While Gradient Mode
- Colourful Chase Mode
- Colourful Strobe Mode
- Red Solid Color Mode
- Blue Solid Color Mode
- Green Solid Color Mode
- Purple Solid Color Mode
- Light Blue Solid Color Mode
- Yellow-green Solid Color Mode
- White Solid Color Mode
- Music Sync Mode
Precautions
- Connect the lights and then power on to lest whelher it works. It can be dangerous to power on during the installation process. Please power on after installation.
- Do not twist the light bar during installation to prevent the light bar from breaking or disconnection.
- When replacing the remote control or control box, press any key on the remote control to pair the remote control and the control box within 5 seconds of power on.
Troubleshooting
- If the light turns off but occasionally turns on automatically Check: Whether there is any looseness between the power cord of the control box and the battery.
- If the light works before installation. but not after installation Check: Whether the connection port between the lamp and the main controller is loose.is the main controller and the Battery positively and negatively connected.
- when the remote control does not work Check: Whether the remote control battery is charged. Then reconnect u,e control box. press any key on the remote control to re-pair within 5 seconds of power on.
- When half of the bar lights are off or there is only one colour in the seven colour modes Check: Whether the light bar is twisted or damaged, if it cannot be repaired, it should be replaced.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>