LUVERNE 4055103 VersaTrac Mounting Brackets Instruction Manual
- May 15, 2024
- LUVERNE
Table of Contents
INSTALLATION MANUAL
4055103
This is the first of two manuals required to complete this installation.
The second manual is included with your side bars / running boards.
Level of Difficulty
Easy
Parts List
| 2 | Mounting bracket, front |
|---|---|
| 4 | Mounting bracket, center / rear |
| 12 | Hex bolt, M8 |
| 12 | Flat washer, M8 |
| 12 | Lock washer, M8 |
| 12 | Hex bolt, M10 |
| 12 | Flat washer, M10 |
| 12 | Lock washer, M10 |
| 12 | Hex Nut, M8 |
Tools Required
| Ratchet | Socket set |
|---|---|
| Torque wrench | Socket extension |
Torque Specifications
| M8 bolt | 7 ft-lbs. |
|---|---|
| M10 bolt | 35 ft-lbs. |
Use above torque setting unless otherwise noted
Product Photo
NOTICE
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time
required.
To help prevent damage to the product or vehicle, refer to the specified
torque specifications when securing hardware during the installation process.
Maintenance
To protect the product, wax after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax
that may contain abrasives that could damage the finish.
For polished, gloss and other smooth finishes, polish may be used to clear
small scratches and scuffs on the finish.
Mild automotive detergent may be used to clean the product. Do not use dish
detergent, abrasive cleaners, abrasive pads, wire brushes or other similar
products that may damage the finish.
Product Registration and Warranty
CURT Group stands behind our products with industry-leading warranties.
Provide feedback and help us to improve our products by registering your
purchase at:
warranty.curtgroup.com/surveys
Step 1
Starting on the driver side, locate the three mounting locations underneath
the vehicle and remove the factory plastic thread plugs.
Step 2
Using two M10 bolts, lock washers and flat washers, install the front mounting
bracket.
Snug the hardware, but do not fully tighten.
Repeat this process for the middle and rear mounting locations. 
Step 3
Repeat step 2 for the front, middle and rear mounting locations on the
passenger side.
Note: To complete the installation, refer to the manual included with
your running boards / side steps.
LUVERNETRUCK.COM
• NEED ASSISTANCE?
• 87 7. 28 7. 8634
• 4055103-INS-RC
• ECN 8188
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>