MicMol Dropum Desktop Micro Landscape Lighting System User Manual
- May 15, 2024
- MICMOL
Table of Contents
MicMol Dropum Desktop Micro Landscape Lighting System
Congratulations
Congratulations on purchasing your Drop
Read this guide to get started to installing and setting your lighting
Drop Controller Overview
Timer Setup
- First Press for 4 hours, the light will flash once.
- Press again for 6 hours, the light will flash 2 times.
- Press again for 8 hours, the light will flash 3 times.
- Press again for 10 hours, the light will flash 4 times.
- Press again for 12 hours, the light will flash 5 times.
Restore the 24-hour keep lighting by holding on for 3 seconds.
Note: The timer will start after you set it up.
Lighting Intensity Adjust
Hold on to adjust the intensity to 0~100% and 100%~0% under Intensity adjust mode.
Information
ATTENTION: Never put the light and the smart controller in the water. Doing so will dangerous and damage your light.
WARNING: Do not touch the lights body when it working which will generate heat and may let your hands uncomfortable.
WARNING: Make sure all the cables are connected before plug to electricity or will damage your light.
Important Handling Information
NOTICE: Failure to follow these handling instructions could result in damage to your Light or other property.
Carrying your Light before you move your Light, shut it down and disconnect all cables and cords connected to it. Using power cord Never force a connector into a port. Don’t put the power cord into your tank when it connected. When you Setup your Light please make sure that it locate power supply where it will not be exposed to any water or moisture.
Mount your power supply where it won’t get wet. Include a “drip loop” – a tied loop of cord hanging down below the level of the electrical outlet. That way, if water happens to run down the cord from the tank, it will drip off onto the floor rather than into the outlet. Drip Loops should always be used to help prevent water from traveling along the cord and coming into contact with an electrical outlet. Drip loops must always be below the level of the outlet. If the plug or outlet does get wet, DO NOT TOUCH the cord.
Storing your Light If you are going to store your Light for an extended period of time, keep it in a cool location (ideally, 71° F or 22° C).
When cleaning the outside of your Light, first shut down your Light and unplug the power cord. Then use a damp, soft, lint-free cloth to clean the lamp exterior. Avoid getting moisture in any openings. Do not spray liquid directly on the lamp. Do not use aerosol sprays, solvents, or abrasives that might damage the finish.
MicMol and the Environment
MicMol. recognizes its responsibility to minimize the environmental impact of its operations and products.
Warranty
MicMol warrants all MicMol products to be free from manufacturing defects for one year from the original purchase date when purchased through an authorized MicMol retailer. This warranty does not cover any damages caused by misuse, neglect, alterations or improper handling / transport / maintenance / installation. Physical damages are not covered by warranty. MicMol does not cover personal injury, personal loss, or other damages associated with the use of our products. In order to request warranty service, please email us at [email protected]. A purchase receipt is required for any warranty service. Products requiring warranty service must be returned to MicMol or authorized MicMol retailer. You are responsible for the cost of shipping a warranty claim to MicMol and any damages that may occur during transit. Once a returned product has been inspected, it will be repaired or exchanged at our discretion and returned to you. Thank you very much.
Customer Support
© 2012~2024 MicMol Limited. All rights reserved.
MicMol, the MicMol Logo, Drop, Master, THOR, Air Pro, Aqua CC, Aqua mini, Aqua
Pro, Aqua Air, BloomBee are trademarks of MicMol registered.
https://www.micmol.com – D0012-2403-A Printed in China.