Insoma 1128 Water Flow Meter for Garden Hose User Manual
- May 15, 2024
- Insoma
Table of Contents
Insoma 1128 Water Flow Meter for Garden Hose
PRODUCT OVERVIEW
SPECIFICATIONS
| Waterproof | IPX6 |
|---|---|
| Water Flow Rate | 1~ 45.5L/Min (12.0GAL/Min) |
| Max Water Consumption | 99999L / 99999GAL |
| Working Pressure | 0.5~10.0Bar |
| Max Flow | 45.5L/Min or 12.0GAL/Min |
| Measurement Tolerance | ±5% |
| Water Temperature | 3℃ ~ 65℃ |
| Battery Model | CR2032 3V |
| Suitable for | Sprinkler, 3/4 inch standard faucet hose |
- When the flow rate exceeds 45.5L/Min or 12.0GAL/Min, the LCD will display HHHH.
QUICK INSTALLATION
Pressing the button to switch these four modes
- Flow Mode — Measure the real-time water flow. When the water is through the flow meter, the LCD will be activated and show the current flow in GAL/Min or L/Min.
- Consumption Mode — Measure the single water consumption. Press the button to show the last time water usage. Hold the button 3 seconds to reset the consumption. At next watering, the display starts at 0 again
- AVG Mode — Display the daily average water consumption for the last 7 days. Press the button to show the latest 7 days’ average water consumption. Hold the button 3 seconds to reset the Average.
- Total Mode — Water quantity is measured up to the reset. Press the button to show total water consumption, Max 99999L /99999GL. Hold the button 3 seconds to reset the Total.
- Switch L & GAL Unit — Under the FLOW MODE, press and hold the button for 3sec to switch the format between L/Min and GAL/Min.
- Standby — No display (Without any operation or flow longer than 1min).
- Low Battery Indication — lease change a new battery when the symbol appears.
FAQ
Q: Why is the flow meter inlet connector leaking?
A: The water leakage might be due to:
- The filter is not installed correctly.
- There is a gap in the connection between the connectors and the filter washer. Please make sure the filter stays flat inside the inlet hole. Use the PTFE thread seal tape to wrap the faucet hose or add a washer to the flow meter connector.
Q: Can I use the flow meter to measure air or hot water?
A: It’s not recommended to measure air. Please strictly control the water
temperature below 140 (60 ) for the hot water.
Q: What if the flow meter does not work?
A: Please check if the battery is installed in the correct direction. If not,
please take out the battery and reinstall it, make sure the battery’s positive
side faces out, and ensure battery poles are clean and free of rust.
Q: Why the water traffic is getting smaller?
A: Maybe the filter is blocked by dust or small grit, please change a new
filter for the flow meter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>