mivo M1 Bluetooth Earphones User Guide

mivo M1 Bluetooth Earphones

Packaging List

• Open-Ear headphones x1

• Charging Case x1

• USB type-C cable x1

• Manual x1

Product Introduction

Power On & Pairing

Pair 1-With Charging Case

1. Take out the earbuds from charging case.

2. Select “M1” from Bluetooth list.

Pair 2-Without Charging Case

1. Lone press both earbuds for 4 seconds until the indicator lights flash red and blue.
2. Select “M1” from Bluetooth list
   

Music

Pause /Play
Tap Twice

Change Song
Long Press 2 seconds
Left bud: Previous track
Rightbud: Next track

Adjust Volume
Tap Once
Left bud: Volume down
Right bud: Volume up
(Note: When the max & min volume is reach, there will be “DIDI” prompt)

Voice Assistant
Tap the earphone 3 times
(Note: Standby or non-music state)

Incoming call

Answer/End a call
Tap twice either bud

Decline a call
Long press either bud for 2 seconds

How to wear it?

1. Pick up
   

2. Rotate along ear curve
   

3. Check fit
   

4. You are all set
   

Power Off

With Charging Case
Put the earbuds into the charging case

Without Charging Case
On Pairing, long press either earbuds for 6 seconds Or turn off Bluetooth.

Note:
When the earbuds is disconnected 5 minutes long or when the battery voltage of the earbuds are lower than 3.1V, the buds will automatically power off.

Charging

Earbuds:
Earbuds LED Light On: Charging
Earbuds LED Light Off: Fully Charged (about 1.5 hours)

Charging case:
Charging Case LED Light Blinking: Charging
Charging Case Green LED Light On: Fully charged (about 1.5 hours)

Reset the Earbuds

When both earbuds fail to pair with each other or occur connection related issues, please follow below steps:

1. Delete the ‘M1’ Bluetooth name from your phone and turn off Bluetooth.
2. Put the earbuds back to the charging case and white LED Light on.
3. Long press both earbuds for 8 seconds until the LED lights flash red and blue 3 time.
4. Open charging case cap.
5. Turn on Bluetooth and click ‘M1’ from your phone.

Q&A

Q: Why the music cuts in and out sometimes?
A: Please make sure there is no obstacle between the earphones and your device. Please make sure there is no Microwave oven /Wifi transmitter around you, which are more likely to produce electromagnetic interference and result in signal interruption.

Q: AreM1 water and sweat resistant?
A: M1 earbuds is water-resistant. The earbuds are designed to be resistant against dust and drops of water but aren’t meant to be submerged under water. We don’t recommend you wear them in heavy rain or wash them with running water.

Q: How to contact Customer Service Team?
A: If you have any issue with the product, please contact us via.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.

Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement in portable exposure condition without restriction.

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference
2. this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Disposal and Recycling Information

This symbol (with or without a solid bar) on the device, batteries (included), and / or the packaging, indicates that the device and its electrical accessories (for example, a headset, adapter or cable) and batteries should not be disposed of as household garbage.

Warning:

1. Don’t place the product into a liquid environment or avoid the product exposed to high humidity
2. Avoid extrusion to avert the damage to the product
3. Don’t attempt to dismantle the product. Put the product in a cool and dry place to keep it dry if stored for a long time
4. Avoid touching the strong magnet to prevent the magnetic headset from being demagnetized.
5. Avoid the dusty, wet and dirty environment where the electronic circuit of the equipment may be damaged if being used.
6. Don’t Use the equipment at the moment of thunderstorm because thunderstorm may incur equipment fault or shock hazard.
7. Don’t use the equipment when riding a motorcycle or a bicycle, driving a car or crossing the road to ensure your safety.
8. Keep the equipment out of reach of children or pets to avert the damage.
9. Don’t wash the equipment with chemical cleanser or strong detergent. Don’t Listen to the voice under high sound pressure and high volume for a long time to prevent the possible hearing impairment when the headset is used.

Battery warning

The built-in lithium battery of the product is forbidden to be disassembled, impacted, extruded or put into fire. The battery under the very low air pressure may result in explosion or flammable liquid or gas leakage. Avoid the battery in a high-temperature environment or being exposed to strong sunlight to avert explosion. Don’t use the battery continuously in case of serious ballooning. The battery shall be handled pursuant to the local regulations and shall not be disposed as household garbage. Don’t try to repair, remove or refit the battery. The explosion may happen if the battery is replaced by the one subject to incorrect model. Don’t compress or puncture the battery with hard object. The battery leakage, overheating or outbreak of a fire may occur if the battery is destroyed.

Customer Support

US: us_supportcare@163.com
UK: uk_support@126.com
EU: Eu_supportcare@163.com
We will reply to you within 24 hours and 100% solve your issues.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>