RYOBI A90PG01 Sanding-Grinding Rotary Kit Instruction Manual
- June 3, 2024
- RYOBI
Table of Contents
45° PLATFORM GUIDE
A90PG01
For use with RYOBI FVM51, TVM01, RRT100, RRT200 Rotary Tools.
WARNING!
To reduce the risk of injury, user must read and understand the operator’s
manual for their rotary tool and this instruction sheet. Always wear eye
protection with side shields marked to comply with ANSI Z87.1. Ensure
compatibility and fit before using this accessory. Do not use this accessory
if a part is damaged or missing. If you are not comfortable performing any of
the functions described in these instructions, take your unit to an authorized
service center.
WARNING:
Never install, remove, or adjust any attachment head while rotary tool is
running. Failure to stop the motor can cause serious personal injury. Never
operate rotary tool without an attachment head or the collar installed.
NOTE: Follow all guidelines and warnings in your rotary tool operator’s manual.
Use the platform guide to control the depth and position (up to 3/4 in.) of the bit when grinding and sanding with your rotary tool. Use this platform guide to control the depth and position of the bit to make cuts up to 3/4 in. through drywall, plastic, and other materials.
INSTALLING THE 45° PLATFORM GUIDE
Fig. 1
A – Collar
Fig. 2
A – Quick-change collet
B – Accessory
Fig. 3
A – Attachment head
B – Depth stop knob
See Figures 1 – 3.
-
Verify the rotary tool switch is in the OFF (O) position and unplug the rotary tool or remove the battery pack, if applicable.
-
Remove accessories and quick-change collet according to the
rotary tool operator’s manual. -
Hold the collar firmly, then turn it counterclockwise to loosen
and remove. -
Install the quick-change collet and accessory according to the
rotary tool operator’s manual. Ensure collet and accessory are secure. -
Slide the attachment head over the accessory and quick-change collet and onto the threaded end of the tool.
-
Hold the attachment head firmly, then turn it clockwise to tighten and secure.
-
If desired, adjust the depth of the guide by loosening the depth stop knob and sliding the guide forward or backwards. Tighten knob to secure.
USING THE 45° PLATFORM GUIDE
Fig. 4
ONE WORLD TECHNOLOGIES, INC.
P.O. Box 1288, Anderson, SC 29622
Phone 1-800-525-2579
www.ryobitools.com
See Figure 4.
-
Verify the rotary tool switch is in the OFF (O) position and plug in the rotary tool or install the battery pack, if applicable.
-
Select the appropriate speed according to the rotary tool
operator’s manual and start the tool. -
Position the face of the platform guide firmly against the edge of workpiece. The guiding edge of the workpiece must be straight for your cut to be straight.
-
Slowly guide the tool along the edge of the workpiece using side to side strokes.
-
When finished, turn off the rotary tool.
998000806
10-8-21 (REV:01)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>