Magbear MG101 Magnetic Car Mount Holder User Guide
- May 15, 2024
- Magbear
Table of Contents
Model : MG101
Magbear
Magnetic Car Mount Holder
User Guide
Installation Steps
Remove the White Transparent film.
Apply the clear film to the back of your phone.
Remove the white sticker from the metal plates.
Paste the plate at the back of your phone cover.
(Or) Install it inside your phone cover.
Remove the strip from the bottom of the suction cup.
Use the Alcohol Swab to clean any Oils, Polish, Dust Particles from the dashboard surface.
Note: Clean it properly for best & long lasting results.
USE (DASHBOARD)
Let the surface dry & fix the holder at your suitable angle. Apply pressure
for hard grip.
USE (WINDSHIELD)
Wait for 30 mins after fixing. Tap your phone on top of the holder and you are
ready to go.
A: Mgnetic Holder
Strong N40 Magnets Inside
B: Lock
C: Arch Adjust
- Metal Plate (Included)
- Magnetic Holder Lock
- Pivot Arm Adjust
- Pivot Arch Adjust
- Step 1
- Step 1
Product Accessories
Cleaning Wipes Rectangular Metal Plate
Circular Metal Plate Transparent Protective Film
How to use the square metal plate?
Paste the metal plate at the backside of your phone or phone cover. (Use the square film)
(Or) Paste it inside your phone cover. (Make sure the phone cover is not too thick)
360 Rotation
- Telescopic Arm
- Pivots on 225°Arch
- Suction cup Stick-on Dashboard (sticky gel)
- Avoid Air Gaps