PAW PATROL PG-CT081 Pet Toy Car Instruction Manual
- March 6, 2024
- PAW PATROL
Table of Contents
PAW PATROL PG-CT081 Pet Toy Car
Installation Instruction
Short press the stitch button: start/stop the smart car
Switch mode: in the startup state,long press the switch
- Normal mode(steady green light for 3s),automatic shutdown after 5 minutes of operation.
- Smart mode(steady blue light for 3s),automatically enter standby state after running for 5 minutes,reactivate by any touch.
Remote control mode: In startup state,press any direction buttons on the
remote control.
Cancel remote mode: In remote control mode,press the middle button of the
remote control or there is no button operation with 30 seconds.
Indicator Light
Blinking red light:Low battery,needs to be charged
Blinking blue light:charging
Steady green light:finished charging
Please fully charge before using it for the first time
Tips for use
If the wheels of the car are stuck by hair or some other fibers,please clean them in time.
The sensors of car toy will be influenced by strong sunlight or incandescent lighting.Please use them indoors.
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>