LED s light 1000434 Solar Table Lamp Instruction Manual
- June 4, 2024
- LED s light
Table of Contents
1000434 Solar Table Lamp
Instruction Manual
Introduction
Please read these instructions carefully before use.
Assembly
Place the lamp-shade on the foot and press all around, until the two parts snap together.
Initial charging:
If the solar panel is covered with a thin protective film, remove it before
using the product. Remove the solar puck by aligning the arrows on the solar
panel and basket and then lifting the solar panel. The basket may need to be
turned upside down to allow the solar puck to fall out. Remove the solar puck
and remove the pull tab from the battery compartment. Place the solar puck on
top of the basket and turn clockwise to lock it into place. Place the solar
light in a location where it can receive a full 8 hours of sunlight to allow
the rechargeable battery to reach maximum capacity.
Optimal location for charging:
Place the solar light fixture in an area where it can receive direct sunlight
for at least 8 hours each day. Shadowed locations will not allow the battery
to charge fully and will reduce the hours of nighttime lighting. The selected
location should not be near nighttime light sources, such as porch lights,
street lights or pool lights, as these may cause the solar light to turn off
prematurely.
Use the included ground spike to securely anchor the product in place.
Battery Replacement:
NOTE: This operation should preferably be done in the morning on a bright
day.
This will allow the lantern to receive a full 8 hours of sunlight so that the
rechargeable battery can reach maximum capacity.
- Remove the solar puck by turning it counterclockwise. The Product may need to be turned upside down to allow the solar puck to fall out.
- Remove the battery cover by unscrewing the three screws.
- Remove the old battery and replace it with a new AA size 1.2V rechargeable battery of the same or greater capacity (mAh).
IMPORTANT!!! USE RECHARGEABLE NiMH BATTERIES ONLY!
Note: Clean the battery contacts (if needed) and those of the device
prior to battery installation.
- Be sure to insert the battery in proper direction (+/-)
- Replace the battery cover on the solar puck and tighten the three screws.
- Replace the solar puck by turning it clockwise.
Warning:
- Safe for outdoor operation.
- Failure to insert the battery in the correct polarity, as indicated in the battery compartment, may shorten the life of the battery or cause the battery to explode or leak.
- Do not dispose of batteries in a fire.
- Batteries should be recycled or disposed of as per the manufacturer’s recommendations.
- Remove the battery if consumed or if the product is to be left unused for a long period.
Care and Cleaning:
The solar panels should be cleaned periodically with a damp cloth for maintaining optimum performance (to remove dust and debris). Do not place in areas where children normally play, or where they may trip and fall against the solar lantern.
Notes on Disposal
The product is designated for separate collection at an appropriate collection
point.
Do not dispose of the product with household waste. For more information,
contact the retailer or the local authority responsible for waste management.
Care
Before cleaning the unit, disconnect it, if necessary from other components;
do not use aggressive cleaning agents. The unit has been carefully checked for
defects. If nevertheless, you do have cause for complaint, please go back to
the retailer where you bought the product together with your proof of
purchase. We are not liable for damage arising from incorrect handling,
improper use, or wear or tear. We reserve the right to make technical
modifications.
Safety
General Safety
- Read the manual carefully before use. Keep this manual for future reference.
- Only use the product for its intended purposes. Do not use the product for other purposes than described in the manual.
- Do not use this product if any part is damaged or defective. If the product is damaged or defective, replace the product immediately.
- This product shall not be used by children without the supervision of an adult. Children shall not play with the device.
- Do not modify the product in any way.
- Do not expose the product to water or moisture. (IP 20)
- Do not immerse the product in water. (IP 44 – IP 67)
- Keep the product away from heat sources.
- Do not block the ventilation openings.
- Do not look directly into the LED lamp.
- Keep a minimum distance of 1 meter between the lamp and the surface being illuminated.
Electrical safety
- To reduce risk of electric shock, this product should only be opened by an authorized technician when service is required.
- Do not use the product if the cable or plug is damaged or defective. When damaged or defective, it must be replaced by the manufacturer or an authorized repair agent.
- Before use, always make sure that the voltage is the same as the voltage on the rating plate of the device.
- Make sure that the cable does not hang over the edge of a worktop and cannot be caught accidentally or tripped over
Warning
- The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similarly qualified person.
- Caution, risk of electric shock.
- The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire has to be destroyed.
Disclaimer
Designs and specifications are subject to change without notice. All logos,
brands, and product names are trademarks or registered trademarks or their
respective holders and are hereby recognized as such.
Please visit us online on our website: www.shada.nl For
more information about our company and our products,
Documentation
The product has been manufactured and supplied in compliance with all relevant
regulations and directives, valid for all member states of the European Union.
The product complies with all applicable specifications and regulations in the
country of sale.
Formal documentation is available upon request. The formal documentation
includes, but is not limited to the Declaration of Conformity, the Material
Safety Data Sheet and the product test report.
CE declaration
This product complies with the following directives:
LVD: 2014/35/EU
EMC: 2014/30/EU
RoHS: 2011/65/EU
Additionally, for Products with Radio transmitter units:
RED: 2014/53/EU
The complete Declaration of Conformity Document (DOC) can be found here:
http://www.shada.nl/uploads/DoCs/index.html