iSpring GB1 Lead Free Reverse Osmosis Filter Drinking Water Instruction Manual
- May 15, 2024
- iSpring
Table of Contents
iSpring GB1 Lead Free Reverse Osmosis Filter Drinking Water Instruction Manual
Installing the Drinking Water Faucet
1. If your kitchen sink does not have an existing 1 /2″ hole, you will need to drill one. Scan the QR code to access step-by-step instructions on how to safely drill a hole on your countertop and install the faucet.
2. Slip the front plate on the faucet stem, followed by the front rubber washer. Insert the faucet stem into the hole on the countertop. Under the sink, slip on the back rubber washer, and tighten the nut with the plastic wing.
- 1/4” or 3/8” adapters are included. Pick one that fits your plumbing.
3. Slide the quick fitting up into the faucet stem, ensure it sits securely on the base, and then lock it in place by sliding the blue clip under the collet.
4. Insert the BLUE tubing about 1 /2″ into the push-in fitting, and secure it with the blue clip.
HOW TO CONNECT
Cut the tubing end squarely using a utility knife or scissors. Insert the tubing into the quick connect fitting for at least 1 /2″. You will need to wiggle the tube and apply additional pressure to create a seal.
It is highly recommended that you watch the video “How to Connect and Disconnect Quick Connect Fittings I DIV Installation” on YouTube.
Scan for Installation Tutorial Video
+1 678-261-7611
support@123filter.com
www.123filter.com
Atlanta, GA
Scan to Register and
Activate Your Extended
Manufacturer
Warranty Today!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>