Ofuzzi Cyber 1200 Pro Cordless Robotic Pool Cleaner User Manual

Ofuzzi Cyber 1200 Pro Cordless Robotic Pool Cleaner User Manual

Important Precautions

1. Donat power on the cleaner when it is out of the water,

2. Strictly prohibit using the cleaner beyond its operating conditions, Please read the manual carefully, and use it according to the manual. We have no ponty for any loss or injury caused by improper use

3. Use the accessories recommended or sold by the manufacturer only.

4. This model marmly apples to swimming pools with a flat hour,

5. The cleaner should not be used by children under the age of a on people with mental disorders, Please do co under the supervision of the guardian if
   necessary, Please do not allow children to ride on it or plllycsi a toy.

6. Use the original and authorized power adapter ore

7. It must be replaced by the after-sale professionals if the power line is damaged.

8. The power line must be connected to a leakage protected and earthed socket when charging

9. Do not operate the cleaner when there are people in the pool.

10. Always clean and wash the filter tray after use.

11. Power off the cleaner when maintaining dealing or not using it

12. The cleaner should be stored in a cool and ventilated place away from direct sunshine,

13. Charge the battery under the permitted condition. The cleaner should be stored in a cool place when charging meanwhile so not place or be covered with anything to provent the damage of internal electrical components caused by overheating of the power unit.

14. Ority professionals can disassemoke the sealed driving kit of the cleaner

15. Close the pool filtration system before use,

16. The cleaner should be charged every three months if it needs to be stored for a long time. Please use the onginal and authorized adaptar only to ensure that the battery power is maintained at 40-60%, The battery voltage will be lower than the over-discharge protection voltage due to the selfischarge of battery if not charging the battery for a long time, which will lead to fiatal damage to the battery if continuing too long, Please be careful

17. Prohitbit charging the battery under the condition of fire or extreme heat. Do not use or store the chaner near the heat source,

18. Prohibit piercing the cleaner shell with naps or other sharp objects, and prohibit hammering, impacting and throwing the oaken.

Ideal for Residential Flat Bottom Pools

Please note that it’s not an all-rounder

For all above / half above ground pools

For Inground Pools of Flat Bottom (Water Depth < 6.56ft)

Not for deep shallow ends, Can’t clime walls or stairs

Introduction

The robotic pool cleaner Cyber 1200 Pro is a new type of rechargeable automatic cleaning equipment for pools with the function of automatic parking. The cleaning function is upgraded, and the half-way torr-back function is activated for 5-12 times every 20 times the wall is hit, so that the center of the swimming pool is no longer a dead corner for cleaning..

Please read this manual carefully before use.

Appearance & structure

Specifications

Operation instruction

Precautions
a. Install the brush before use to avoid possible dirt leaks,

b. Please erasure that the top cover of the cleaner is tightly assembled to its chassis.

c. After taming on the cleaner must be placed in the pool within 20 seconds

d. Put into or lift out of the pool with the cleaner bottom towards the wall to avoid any possible scratches to the pool.

e. The suction adapter is removable,
f. Power off the cleaner after use.
g. Do not touch the wall to avoid scratching the wolf or damaging the cleaner when putting into or lifting out of the pool.
h. It is necessary to stay on the water surface for 10-15 seconds until water flows out from the deanery to the pool before being placed on the grounds Lift the handle or clips of the cleaner out from the pool.
I. When the floating handle is far away form pool side, use the hook (pole is not included) to reach the floating handle.

Quick operation
a. Plug in the cleaner with the supplied adapter and charging line to charge the battery.

• Turn the switch knob to OFF before charging.
• Clean the charging port before charging.
• Keep the machine charging port and the adapter dry when charging.

b. Turn the switch knob to power on or off the cleaner

• Please put into water within 20 seconds after turning on.
  

c. Turn the switch knob to ON, the cleaner is power-on and the indicator light is steady blue, then put it into water. About 15 seconds after power-on, the cleaner begins to work, and the blue light flashes.
d. When battery power is low the cleaner will move close to the pool wall. The red-light fast flashes, The cleaner stops running when it runs out of battery,
e. Indicators

Functions and adjustment of nazzjes
There are two nozzles on the cleaner, one of them opens once the other closes. Water flows out through the open nozzle to thrust the cleaner forward.
Adjust the nozzle by turning it to control the cleaner route

a. Setting nozzle angle and cleaner route

• The nozzles of the cleaner are marked with angles (0°-40°).

• The cleaner moves in an approximately straight line when the nozzle angle is 0°.

• The cleaner moves in a more curved line at a larger angle from 0°-40°.

• Setting 1: default setting: 0°-20°, for most of pools.
  

• Setting 2: 0°-40°, when setting 1 does not manage a full coverage of the pool.
  

• Setting 3: 20°-20°, for round pools.
  
  Note: These are the recommended settings. Different settings may work better for your pool.

Clean the filter tray
a. Open the cleaner by the clips

b. Take out the filter tray

c. Clean the filter tray and chassis

d. Reassemble the cleaner

e. Clap on the clips

Installation and removal of swing plate
The swing plate can be removed by poking the base buckle outwards and installed by inserting it into the base.

Trouble shooting

after-sales service
The adapter indicator light does not work| Adapter damage| Contact after-sales service
The cleaner does not achieve a full coverage of the pool| Unsuitable nozzle angle| Adjust nozzle angle
Special pool shape| Adjust nozzle to increase angle of deflection
Pool water filtration system is running| Turn off water filtration system
The working time of the cleaner cannot reach MAX 120 minutes| Not fully charged| Fully charge the cleaner (needs to last 3-3.5 hours)
The cleaner cannot reach the shallow water area from the deep water area| The pool slopes more than 15 degree.| Warm Tips Only suitable for flat-bottom pools, not climbing walls or slopes more than 15 degree.

Packing List

Warranty

This product has passed all quality control and safety tests, conducted by the technical department of the factory.

Warranty information:

1. The warranty period is 12 months of use on the motors and electrical parts from the date of purchase and established under the terms of the Consumer Code and the legal guarantee against hidden defects and vices in any case applies in the conditions of the articles in the country of purchase.
2. The warranty is void if the product is handled or repaired by nonqualified person in unauthorized repair services.
3. Broken parts are not covered by the warranty.
4. The warranty only covers factory defects, it does not cover damage caused by misuse of the article.
5. Any claim made or repair made during the warranty period will be subject to mandatory presentation of the invoice.
   

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>